Home >
Basic Circuits >Amplifying Circuits > An amplifier using INA103 to set gain with external resistors
An amplifier using INA103 to set gain with external resistors
Source: InternetPublisher:走马观花 Keywords: Amplifier Updated: 2024/09/12
As shown in the figure, an amplifier with external resistors setting gain is used. The external resistors RF and RG form an amplifier with external resistors setting gain, and the gain G = 1 2RF/RG. When RF>10kΩl, the noise will increase and the bandwidth will decrease.
Latest Basic Circuits Circuits
- FPGA Features and Architecture
- Working principle and truth table of JK flip-flop
- What is power factor and three ways to improve it
- Basic characteristics/working principles and application circuits of tunnel diodes
- How to Build a Simple Temperature Indicator Circuit Using NTC and PTC Thermistors
- Analysis of three simple electronic dice circuits
- LED Bicycle Lights
- An example of proportional integral circuit diagram
- AD108 frequency multiplier capable of inputting asymmetric square wave
- Odd-frequency counter with symmetrical output waveform (μL9020)
Popular Circuits
- mini stereo amplifier
- TDA2030A subwoofer circuit diagram
- MC-1590 IF amplifier circuit diagram
- Amplifier circuit diagram based on 50Ω linear
- High input impedance three op amp differential amplifier circuit diagram
- Low drift peak detector
- Parallel power op amp
- Broadband Difet Op Amp Circuit
- A crystal controlled local oscillator circuit diagram
- Two common-emitter transistor amplifiers connected to form a directly coupled two-stage amplifier
京公网安备 11010802033920号