Interface circuit design of SPCE061A microcontroller and fingerprint identification module
Source: InternetPublisher:张小哥 Keywords: Microcontroller interface control interface circuit Updated: 2021/09/22
The SPCE061A microcontroller communicates with the fingerprint identification module OM-20 through the serial port. There is a standard full-duplex universal asynchronous receiver/transmitter UART inside the SPCE061A microcontroller. The UART's receiving signal Rx and sending signal Tx are shared with IOB7 and IOB10 respectively, which are special functions of port B. Since the serial port of the SPCE061A microcontroller uses TTL level, and the serial port of the fingerprint identification module OM-20 uses RS232 level, level conversion must be performed in order to achieve communication between the two. The RS232 standard is a serial bus standard officially announced by the Federation of Electronic Industries. The RS232 serial interface bus is suitable for communication distances between devices not greater than 15m, with a maximum transmission rate of 20kBps. RS232 uses negative logic to specify logic levels.
Discrete components or integrated circuit chips can be used to achieve RS232 and TTL logic level conversion. At present, the more widely used integrated circuit conversion devices, such as MC1488 and SN75150 chips, can complete the conversion from TTL level to RS232 level, while MC1489 and SN75154 can realize the conversion from RS232 level to TTL level. Figure 3.1 shows the interface circuit between the SPCE061A microcontroller and the fingerprint identification module OM-20. MAX232 is very sensitive to power supply noise, so a 1μf decoupling capacitor is added to Vcc. The capacitors C1, C2, C3 and C4 take 1μf decoupling capacitors to improve anti-interference. ability.
- LED lights that “drain” battery power
- LED Bicycle Lights
- Sunday Reminder
- Homemade 100-base addition and subtraction counting circuit
- Digital control frequency division circuit composed of MC4018
- The quadruple frequency circuit composed of CH7555
- Design circuit of voltage inverter using PWM
- Power-saving LED dimming circuit
- 2450MHz final stage high power linear amplifier circuit composed of RF2126
- 380MHz linear amplifier circuit composed of RF2175
- SPI interface and microcontroller interface principle circuit diagram
- Microcontroller control circuit
- SPI interface and microcontroller interface principle circuit diagram
- Temperature control interface circuit
- Address decoding interface circuit
- Keyboard-display interface circuit
- A microcontroller infrared asynchronous communication port circuit diagram
- Servo motor control circuit
- MAX703 and 704 constitute a microcontroller monitoring circuit
- Method of two-way serial communication between PC and 8031 microcontroller