Contact relay output control interface circuit
Source: InternetPublisher:狂妄火龙果 Keywords: Interface circuit contacts output control relay output Updated: 2021/02/01
When the switching output terminal PAO output is high level, it changes to low level through the inverting driver 7406, causing the light-emitting diode to emit light, thereby
turning on the photosensitive transistor and at the same time turning on the transistor VT, thus energizing the coil of the relay K , the relay contact is closed, turning on
the AC 220V power supply. On the contrary, when the switching output terminal PAO outputs low level, the relay contact is disconnected. In the figure, the resistor RL represents the load
, and the diode VD functions to protect the transistor VT. When relay K is closed, diode VI) is cut off, which does not affect the normal operation of the circuit
. When the relay is released, due to the existence of the inductance of the relay coil, electric energy is stored. At this time, the transistor VT has been cut off, so a
higher induced voltage will be generated at both ends of the coil. The polarity of this voltage is up and negative. Positive, the positive terminal is added to the collector of transistor VT. When the sum of the induced
voltage and Voc is greater than the collector reverse voltage of the transistor VT, the transistor VT will be broken down and damaged. After adding the diode VD
, the induced current generated by the relay coil flows through the diode VD, clamping the extreme voltage of the transistor VT collector, thus
protecting the transistor VT.
- An example of proportional integral circuit diagram
- A practical automatic electronic welcome circuit
- Frequency divider composed of TTL decade counter
- Method for obtaining second reference signal using CMOS pointer-type quartz electronic clock integrated circuit
- LED lights powered by solar cells
- Non-inverting gain circuit composed of MAX4100/MAX4101
- Dual-channel amplifier circuit composed of LM4912
- FET buffer amplifier with high input impedance using INA103
- INA105 precision unity gain buffer circuit
- Precision bridge isolation amplifier composed of ISO101
- Interface circuit design of SPCE061A microcontroller and fingerprint identification module
- Interface circuit between 4-wire resistive touch screen and ADS7846
- Using 74LS244 to expand 24-channel input interface circuit
- Interface circuit between AD574A and PC bus
- Interface circuit between CMOS and HTL b
- TTL and CMOS interface circuit a
- Interface circuit between CMOS and switching amplifier c
- Power supply coupler-thyristor interface circuit c
- Power supply coupler-thyristor interface circuit a
- Interface circuit between power supply coupler and triode b