6185 views|1 replies

2

Posts

0

Resources
The OP
 

Reasons for JTAG programming failure of SOC FPGA [Copy link]

 I am using the smartfusion2 series soc chip from micro semi. When I was burning the program with libero, an error message appeared. The error message seemed to be a voltage problem. There was a warning: Warning: programmer '95364' : Vpump has been selected on programmer AND an externally provided Vpump has also been detected. Using externally provided Vpump voltage source. The error was Error: programmer '95364' : device 'M2S010' : Executing action PROGRAM FAILED, EXIT -22, refer to FlashPro online help for details. After reading the error details of -22, it showed Failed to program pass key. Possible reasons are: Unstable VPUMP voltage level. Unstable VCC Unstable VCC_OSC (Fusion only)Unstable VCC_ROSC voltage level (SmartFusion only) Signal integrity issues on JTAG pins. Please ask all the experts how to troubleshoot the problem

5.png (85.49 KB, downloads: 0)

运行结果2

运行结果2

4.png (187.52 KB, downloads: 0)

运行结果1

运行结果1

3.png (126.9 KB, downloads: 0)

错误详页

错误详页
This post is from Altera SoC

Latest reply

Is this problem solved? I have the same problem.   Details Published on 2024-1-20 10:30
 
 

15

Posts

0

Resources
2
 

Is this problem solved? I have the same problem.

This post is from Altera SoC
 
 
 

Guess Your Favourite
Just looking around
Find a datasheet?

EEWorld Datasheet Technical Support

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号
快速回复 返回顶部 Return list