logo Training

xilinx zynq fpga video tutorial

Total of 58 lessons ,1 days and 9 hours and 42 minutes and 59 seconds
Profile

This tutorial explains the basics of FPGA, introduction to SOC, DMA and VDMA, linux, HLS images and PCIE

Suitable for the following applications:

High-speed communications; machine vision, robots; servo systems, motion control; video collection, video output, consumer electronics; early stage verification of project research and development; learning for developers in electronic information engineering, automation, communication engineering and other electronic related majors

Chapters
Unfold

You Might Like

Recommended Posts

【TIVA C launchpad study notes 1】 LCD12864 display, can display ASCII, Chinese, dot plotting
/******************************************* Development environment: CCSv5 Program function: LCD12864 display, can draw points and draw pictures, display Chinese characters, ASCII Program description
Linchpin Microcontroller MCU
Circuit board power supply
There is a 2.5V power supply on the existing PCB circuit board. Without soldering the magnetic beads, the measured voltage is 2.5V, which is normal. But after soldering the magnetic beads, the measure
xxhhzz Integrated technical exchanges
EEWORLD University Hall----Development and testing of the next generation HDMI interface (Part 1)
Development and testing of the next generation HDMI interface (Part 1) : https://training.eeworld.com.cn/course/2294
phantom7 Test/Measurement
After RAS dial-up connection, an incorrect IP and subnet mask are obtained
I recently debugged a 3G network card. The driver under wince has been basically completed. The dial-up connection can also be established and it shows "connected" after dialing. However, I cannot ope
chokee Embedded System
Arduino AVR Development
Is there anyone who can move the Arduino program to the Avr development board? I want to learn~
第七天魔王 MCU
What is the difference between a program with a queue and one with only a buffer in a serial port? How to distinguish between them?
As the title says, I have seen some serial port programs. Queues are set up. There are also head and tail pointers, and data counts. Some only set up buffers. May I ask, when to use which method? In a
yanse51 stm32/stm8
Recommended Content

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号