[Gizwits Gokit3 Review] Part 3: One-click Internet access, can you get started?

w494143467

[Gizwits Gokit3 Review] Part 3: One-click Internet access, can you get started? [Copy link]

 

1. Introduction

In the previous article, I created a product. In this article, I started to connect to the Internet. Connecting to the Internet is also very simple, but I also encountered some pitfalls. Let me tell you slowly.

2. Networking steps

First, unzip the downloaded program, then open the folder, you can see the content as shown in Figure 1, copy the content in the red box.

Figure 1

To the path shown in Figure 2 below.

Figure 2

Then open the program. You need to install the Arduino IDE here. Of course, if you have developed Arduino, you don’t need to install it. Comment out the part in the picture below. Because there is only one serial port and it needs to communicate with the WIFI module, it needs to be commented out. Otherwise, the communication will fail and you will not be able to connect to the Internet. Finally, change the method of quoting the header file [""].

Figure 3

Figure 4

Figure 5

Then change the category of the development board to Arduino Uno.

Figure 6

Change the download port.

Figure 7

Separate the two development boards, connect the serial port cables, and prepare to download the program.

Figure 8

After downloading the program, it will appear as shown in Figure 9.

Fig. 9

Finally, close the two development boards and press and hold [Key2] for more than 3 seconds.

Fig.10

Open the official website, enter the developer center, click Download Center, find the download QR code as shown below, and scan it with your mobile phone to download.

Fig.11

Open the software, skip registration, click Add Device, and click One-Click Configuration.

Fig.12

Choose the corresponding WIFI. This is the key point. This is where I got into the trap! I chose the [Xiaomi router], but it couldn't connect to the Internet. It felt like it was restricted. After changing the modem, it was able to connect to the Internet normally!

Fig.13

The network configuration interface is shown in Figure 14.

Fig.14

After the device is found, it is shown as shown in Figure 15. Since I have already configured it, it is displayed in the commonly used devices.

Fig.15

Finally click on the added switch and that’s it!

Fig.16

Fig.17

3. Summary

It is very simple to join the network, but the pit has stuck me for a while, I am very helpless, I tried many ways, and even changed the mobile phone in the middle, but unfortunately it didn’t work. Finally, I felt that it was a problem with the router. I changed the router and it was perfectly connected to the network. What a pitfall!!!

Jacktang

Why Xiaomi router configuration failed?

w494143467

Jacktang posted on 2021-3-20 21:01 Wondering why the Xiaomi router configuration failed

I don't know, is it because of the dual mode? Or is it restricted by the Xiaomi router? But I checked some configurations and it's not restricted.