[Gizwits Gokit 3 Review] Device Access-Step 4: Connect to the Internet

annysky2012

[Gizwits Gokit 3 Review] Device Access-Step 4: Connect to the Internet [Copy link]

 

1. Write in front

After downloading the firmware ( 【Gizwits Gokit3 Review】Device access-Step 3: Download program firmware ), you will use the mobile phone APP to connect to the Internet and view the data.

2. Tools

cell phone

Gizwits Cloud APP

Gizwits Cloud Suite

3. Networking steps

(1) First, download the Gizwits Cloud app from the Download Center ( https://download.gizwits.com/zh-cn/p/98/99 ). You can choose the one based on the system of your phone. I chose Android.

Please note that if you cannot download the file by scanning the QR code in the download center, you can just click on the download link directly.

(2) Open the Gizwits Cloud app and register and log in to the app account

(3) Short press the key2 button in the middle of gokit to put the WiFi module into softap network configuration mode. At this time, the RGB full-color light turns red.

(4) Open the APP, click "Add Device", and configure gokit to connect to the network:

Select "One-click configuration"

Connect to WIFI. The development kit and mobile phone are in the same WIFI.

Select the module. Here, select Espressif and set it according to your development board.

Wait for configuration to complete

After the configuration is complete, the current device will be displayed:

Special note: Choose the module according to your own development kit. I use Espressif.

(5) Use mobile phone APP to control/read device data

(6) In the Developer Center, click on the device and view your "Device Log" to clearly see your device data and status.

w494143467

I can't seem to connect using the factory program directly. Does this happen to you?

freebsder

Thanks for sharing!

littleshrimp

w494143467 posted on 2021-3-3 19:43 I can't seem to connect directly using the factory program. Do you have this problem?

Any hints?

w494143467

littleshrimp posted on 2021-3-4 11:29 Any tips?

I kind of forgot, I'll take a look at it when the time comes!

annysky2012

w494143467 posted on 2021-3-3 19:43 I can't seem to connect directly using the factory program. Do you have this problem?

I didn't use the factory program because I don't know where it is.

annysky2012

freebsder posted on 2021-3-3 22:04 Thank you for sharing!

Thanks for your support

annysky2012

w494143467 posted on 2021-3-4 12:38 I forgot a little bit, I will take a look at it when the time comes!

Is there something wrong with your settings? Or is the connection not good?