The analyzer host computer directly uses Wireshark. The hardware is implemented using Cypress CY7C68013A MCU + Lattice LCMXO2 FPGA + Microchip USB3343 USB PHY
Breakout board for Lattice HX4K FPGAs with 10 PMOD connectors and onboard microcontroller for programming and communication via USB.
There are three boards in total, USB, FPGA and Sensor board. The FPGA board features a Lattice Crosslink NX LIFCL-40 and the required power regulator, and the USB board features a CYUSB3014 USB 3.0 SuperSpeed controller.
Through this open source tool, everyone can better understand how program firmware is "exploded", thereby improving product security. Crack AES, crack RSA, crack DES and so on.
Introduction: A development board based on ZYNQ7010, with the same size and interface as the Raspberry Pi.
The board has the same interface as the Raspberry Pi, four USB2.0, Gigabit Ethernet, one HDMI, one power interface, and one debugging Serial port, one programming port, one SD card interface, and a set of GPIO.
Introduction: EPM240T100C5N CPLD learning board
Note: JTAGE is not connected to the pull-down resistor, but it can be downloaded for personal testing. Not compatible with EPM570, please pay attention to the chip model.
Introduction: Imitation microphase FPGA development board
Introduction: MAX-II development board: EPM570F256C5N
Introduction: With the progress of very large scale integrated circuit technology, the integration level of integrated circuits continues to increase and the scale becomes larger and larger. Core-based design has become an inevitable trend in the development of EDA. Due to the emphasis on design ideas and design knowledge, the design process is reduced. Cost and design cycle, IP core has become an important design method for system-on-chip
Introduction: A cheap DAC module, 10bit parallel port input, output analog voltage. Cost as low as 1 yuan
Introduction: xc7z010 core board test board, ok ZYNQ7010, ARM9 dual-core, 28kLUT. Some schematics are not added to the PCB. The added test is OK, indicating that the core board is ok. You can make the board yourself to verify it. Of course, you can also buy it directly.
Introduction: FPGA implements DDS arbitrary waveform generator
Introduction: Related boards for getting started with CPU customization (author @yone2_net) V1.2