Training

Location:Training / Webinar / FollowMe Season 2: 2 - Arduino UNO R4 Wi-Fi and Tasks / Arduino UNO R4 Wi-Fi and Tasks

Chapter 1：Arduino UNO R4 Wi-Fi and Tasks

Duration：35 minutes and 59 seconds
Date：2024/08/27

Uploader：hi5

Introduction

keywords： Wi-Fi Arduino FollowMe A R4

Follow me is a large-scale development board experience event jointly initiated by DigiKey and EEWorld. In each issue, technical experts recommend development boards/instrument kits that are easy to play and learn, and take everyone to actually operate. Participants can return JD.com cards after completing the tasks. There are four events in this season, and this event is the second one.

You Might Like

Recommended Posts

F2H_SDRAM Issues: DE1-SoC board, the program uses avalon mm's Burst mode communication, and there are two modules that need to access DDR3, one for reading and one for writing. If both are connected to the f2h_axi_slav; cncqzxj FPGA/CPLD

Dual power switching circuit error correction: [i=s]This post was last edited by huiyu2018 on 2016-11-8 16:51[/i] Hi everyone, I am working on a project recently and need a dual power switching circuit. Since using two diodes will result in a larg; huiyu2018 Power technology

433M wireless positioning: Can I use 433M wireless positioning?; hinii23 RF/Wirelessly

I'm begging for help from Quartus II and SOPC Builder experts. SOPC Builder opens with an error.: As the title says, I am a beginner in SOPC Builder. I have installed Quartus II and Nios II. Nios II can open Quartus II and complete compilation normally, but when I open SOPC Builder under Quartus I; DONG1035 Embedded System

Shanghai bans taxis from using taxi apps during morning and evening rush hours: Shanghai, Feb. 26 (China News Service) - In response to the chaos in the taxi market caused by "taxi apps", the Shanghai Municipal Transportation and Port Administration announced on the evening of th; xuyiyi Talking

I bought a switching power supply that outputs +12.5V. How can I get a +12V1A low-ripple voltage output?: Is there an LDO chip that can be used directly? Or should I first boost the voltage and then use an LDO chip to step down the output voltage?; guazhuaq Power technology

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号