[i=s]This post was last edited by littleshrimp on 2019-1-4 17:59[/i] In the sprinkler example provided by the official Out of Box, the image update and the LED flashing of the development board will b
Using MCU serial port to simulate PROFIBUS Reprinted from: http://www.china-plc.com/read.asp?/111.htm A while ago, a project came up, requiring the implementation of PROFIBUS protocol on a single-chip
The ch32v103c8t6 board was developed using the MounRiver Studio tool. The integration of this tool is good, but the project templates are a bit "simple". It seems that it is a bit confusing to study t
I want to find an op amp with 100MHz bandwidth, 5V/us or higher slew rate, and 1G ohm input impedance. I searched a lot but none of them meet the requirements. Has anyone used an op amp that meets thi
65816 Interrupts There are some oddities with the 65816 interrupts that you should consider. If you are planning to write 65816 native code, you should consider how your interrupt routines are handled
[i=s]This post was last edited by Yishayishi on 2022-9-28 09:59[/i]In PROTEL99, you can use the FIND button in the figure below to find which library a component in the schematic diagram is in, but wh