Hello everyone, I just learned altium designer and I want to ask for help. When I imported the schematic diagram to the PCB board, the following prompt appeared. How can I solve it?Thank you everyone
How to perform system enumeration in Wince directshow? Directshow under Wince does not support system enumeration, and there is no ICreateDevEnum interface, so system enumeration cannot be performed.
[i=s]This post was last edited by mzb2012 on 2017-3-31 23:43[/i] Thanks to EEworld, thanks to TI, the camera I have been waiting for for a few days has finally arrived today, a very powerful night vis
The right side of the dotted line should be extracting the AC signal, filtering it and then amplifying it, but I don't understand what the principle is
I want to process a sine wave (frequency of tens of kHz, peak-to-peak value -1.5V to +1.5V) into a square wave through a pulse shaping circuit and give it to the FPGA for processing.I looked at severa