Training > Embedded Development

Total of 20 lessons ,6 hours and 47 minutes and 27 seconds

Go study

Profile

Chapters

• Chapter 1： (20 minutes and 22 seconds)

• Chapter 2： (27 minutes and 45 seconds)

• Chapter 3： (26 minutes and 1 seconds)

• Chapter 4： (16 minutes and 15 seconds)

• Chapter 5： (17 minutes and 24 seconds)

• Chapter 6： (12 minutes and 47 seconds)

• Chapter 7： (18 minutes and 27 seconds)

• Chapter 8： (8 minutes and 22 seconds)

• Chapter 9： (6 minutes and 57 seconds)

• Chapter 10： (24 minutes and 22 seconds)

• Chapter 11： (30 minutes and 15 seconds)

• Chapter 12： (26 minutes and 7 seconds)

• Chapter 13： (22 minutes and 10 seconds)

• Chapter 14： (24 minutes and 51 seconds)

• Chapter 15： (15 minutes and 50 seconds)

• Chapter 16： (18 minutes and 25 seconds)

• Chapter 17： (22 minutes and 8 seconds)

• Chapter 18： (17 minutes and 44 seconds)

• Chapter 19： (36 minutes and 54 seconds)

• Chapter 20： (14 minutes and 21 seconds)

Unfold

You Might Like

Recommended Posts

LTCC meets 5G: Advanced filter design enables true mmWave performance

Low Temperature Co-fired Ceramic (LTCC) substrate technology is one of the main areas of RD investment at Mini-Circuits. With long-term investments in materials, manufacturing processes, simulation an

石榴姐 RF/Wirelessly

Rust on Espressif chips

Scott Mabez announced on his blog that he will join Espressif full-time to provide Rust support for all Espressif chips, past, present, and future, including the ESP32-C3 with RISC-V core.https://mabe

dcexpert MicroPython Open Source section

Please tell me how to use GPIO port to light up the eight-segment digital tube

As shown in the picture: the silk screen of the development board is a little fuzzy, I measured and confirmed that it is PC5. Due to time constraints, I did not buy the OLED display module online. I w

yin_wu_qing GD32 MCU

Elderly environmental safety monitoring system based on AMG kit and Nucleo-L476 development board

donatello1996 MEMS sensors

mdkarm3.05 issue target not created

(.text+0x12c):/cygdrive/d/allwork/keil/startup.s:400: undefined reference to '_data' collect2: ld returned 1 exit status target not created

garychan ARM Technology

Infrared light introduction

There are three main types of infrared lamps: Halogen bulbs with filters: The irradiation distance is far, the power is high, but the energy loss is also large. Because of the filter, most of the visi

aone2008 Security Electronics

Recommended Content

Web users are watching Change

• LTCC meets 5G: Advanced filter design enables true mmWave performance
• Rust on Espressif chips
• Please tell me how to use GPIO port to light up the eight-segment digital tube
• Elderly environmental safety monitoring system based on AMG kit and Nucleo-L476 development board
• mdkarm3.05 issue target not created
• Infrared light introduction
• Design of automatic control system based on fieldbus and Ethernet technology
• EMC/EMI Control Technology in PCB Design
• 【Zero Knowledge ESP8266】Tutorial: OLED Weather Clock
• EEWORLD University Hall----Introduction to Isolation Amplifier

• MCU Multimedia Tutorial.iso
• STC12C5A60S2 single chip microcomputer controls GPS positioning, and LCD displays positioning information
• TI WL1271 WiFi Linux Settings
• Comparison of FPGA reliability among major manufacturers
• [RVB2601 Creative Application Development] CDK startup does not respond
• How to use the serial port of Sinlinx A33 development board
• Relationship between Nucleus and ThreadX
• 51 Three questions for beginners. Please give me some advice so that I can avoid taking detours!
• Several issues about gate drivers
• Physical address of DDR3 on DE1-SoC board?

• In-depth analysis | RF front-end technology in the 5G era
• XILINX FPGA Chip
• Japan develops "power suit" that increases wearer's strength 10 times
• Studying the road to electric motor drive - 7: Mathematics used in electric motor drive
• Design of a Frequency Shift Keying Wireless Modem
• Two ADCs collect two signal sources. If one of them is not commented out in the program, the two sets of detected signals will always...
• FAQ: How to design an efficient and reliable USB PD power supply in minutes - PI Expert step-by-step tutorial
• AVRJTAG emulator complete home made
• Design strategies for local oscillators in CDMA mobile phones [multiple images]
• Question about "LDR" assembly pseudo-instruction in ARM Cortex-M0

Popular Components

1. AME1117BCGTZ
2. MMSZ5228B
3. PJT7800_R1_00001
4. 1.5SMC250CA
5. 1SMB3EZ25-AU_R1_100A1
6. A1255HA-2P
7. C4201WVA-2x2P-V0-HCS
8. A2547HJ-15P-GY
9. MWSA0603S-150MT
10. 0805W8F1182T5E

Just Take a Look

1. LTCC meets 5G: Advanced filter design enables true mmWave performance
2. Rust on Espressif chips
3. Please tell me how to use GPIO port to light up the eight-segment digital tube
4. Elderly environmental safety monitoring system based on AMG kit and Nucleo-L476 development board
5. mdkarm3.05 issue target not created
6. Infrared light introduction
7. Design of automatic control system based on fieldbus and Ethernet technology
8. EMC/EMI Control Technology in PCB Design
9. 【Zero Knowledge ESP8266】Tutorial: OLED Weather Clock
10. EEWORLD University Hall----Introduction to Isolation Amplifier
11. MCU Multimedia Tutorial.iso
12. STC12C5A60S2 single chip microcomputer controls GPS positioning, and LCD displays positioning information
13. TI WL1271 WiFi Linux Settings
14. Comparison of FPGA reliability among major manufacturers
15. [RVB2601 Creative Application Development] CDK startup does not respond
16. How to use the serial port of Sinlinx A33 development board
17. Relationship between Nucleus and ThreadX
18. 51 Three questions for beginners. Please give me some advice so that I can avoid taking detours!
19. Several issues about gate drivers
20. Physical address of DDR3 on DE1-SoC board?

Hot Downloads

• u-boot source code
• VHDL Golden_Reference_Guide
• msn message protocol stack
• Freescale S12 Processor Training Notes
• Neural Network backpropagation
• Please try it out. Hopefully, v1.1 will be released soon. Username and password: admin
• Mini2440 non-operating system test code, I hope everyone can learn from it
• KL46 MCU pulse counting program
• Journal article: Digital watermarking technology based on fractal compression coding
• 《Vue2 Practice Revealed》

MoreHot Articles

• More fragrant than OLED! Apple is about to commercialize MicroLED technology: no screen burn-in
• Domestic mobile phone shipments continued to recover, up 1.2% in May
• Volkswagen: Due to chip supply shortage, production plans in China and other markets will be adjusted
• Addressing supply chain challenges with custom semiconductors
• Application and Prospect of LED in Indoor Lighting
• MIT develops pure lithium electrodes and subverts battery design, seeking large-scale production
• UAI: Adhere to the "Integration" Strategy in Overseas Markets
• Design of LCD display system based on LCD module HT1621
• Technical Articles - In-depth Analysis of Real-time Ethernet
• What are the differences between ARM, Intel, and MIPS processors?