The traditional way to judge whether a bit is 1/0 is if(varx == 0x01), which is slow, so I would like to ask if there is an assembly instruction to directly get the overflowed bit.
Has anyone written an FPGA program for LTC2640? I don't know why the simulation timing is always correct but there is no output voltage when the program is downloaded.
[font=微软雅黑][b][color=red]Introduction[/color][/b] Semiconductor device obsolescence is an ongoing issue for every electronics manufacturer today, and it will always be. Purchasing replacement devices
Reset StateAfter a BOR, the initial device condition is:RST/NMI pins are configured in reset mode.I/O pins are switched to input mode.Status register (SR) is reset.Watchdog timer is powered on in watc
[i=s]This post was last edited by star_66666 on 2018-1-10 12:39[/i] Yesterday I found a new GUI in a forum. It was very small and I wanted to try it. The official version is v0.3 and the official webs