• You can log in to your eeworld account to continue watching:
  • Thread synchronization
  • Login
  • Duration:9 minutes and 7 seconds
  • Date:2019/04/09
  • Uploader:抛砖引玉
Introduction
keywords: Linux STM32 Embedded
Embedded software design is a professional course in computer, software engineering and other disciplines. It is an important course with strong practicality and technical nature. The main task of this course is to comprehensively introduce GNU C language programming ideas and methods based on ARM/embedded Linux operating system, as well as embedded simulation technology based on STM32 processor and Proteus. Through the study of this course, students can master the basic processes and methods of embedded software design.

Unfold ↓

You Might Like

Recommended Posts

TMS320F28035 bidirectional 400V-12V DC/DC converter design
The Bidirectional 400V-12V DC/DC Converter Reference Design implements an isolated bidirectional DC/DC converter using a microcontroller-based approach. A phase-shifted full-bridge (PSFB) with synchro
Jacktang Microcontroller MCU
Why are the component angles in the AD09 component package library all changed to 10 degrees?
The AD09 component was normal when I pulled it out of the library just now. I don't know where I pressed it just now. The package I pulled out of all the libraries is 10 degrees. How can I change it b
天在山之外 Integrated technical exchanges
How to improve the load capacity of power chip
I built a bandgap circuit at school according to the structure of a foreign chip, but the simulation found that the load capacity is not good; and I have to add capacitors to sacrifice bandwidth to co
芝麻薄脆饼饼 Analog electronics
ESP32 development board that looks like Raspberry Pi Zero
The ATMegaZero ESP32-S2 is an ESP32 development board that looks just like the Raspberry Pi Zero, which means the shape and 40-pin GPIO interface are the same as the Pi Zero, and the same accessories
dcexpert MicroPython Open Source section
Where is the best place to place the ESD on the PCB?
[i=s]This post was last edited by we36147 on 2022-9-26 01:25[/i]Where is the best place to place the ESD on the PCB?
we36147 Analogue and Mixed Signal
High pass filter, low pass filter, notch filter
High pass filter, low pass filter, notch filter High-pass filter cutoff frequency:f H =1/2π × 510 ×10^3×10 ×10^-6= 0.03 Hz Low-pass filter cutoff frequency:f L =1/2π× 1.5×10^3×1×10^-6= 106 Hz Notch ce
QWE4562009 Circuit Observation Room

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号