Training

Location:Training / Embedded Development / Embedded software design / Linux shell

You can log in to your eeworld account to continue watching：
Linux shell
Login

Duration：9 minutes and 5 seconds
Date：2019/04/09

Uploader：抛砖引玉

Introduction

keywords： Linux STM32 Embedded

Embedded software design is a professional course in computer, software engineering and other disciplines. It is an important course with strong practicality and technical nature. The main task of this course is to comprehensively introduce GNU C language programming ideas and methods based on ARM/embedded Linux operating system, as well as embedded simulation technology based on STM32 processor and Proteus. Through the study of this course, students can master the basic processes and methods of embedded software design.

You Might Like

Recommended Posts

Typical applications of acceleration sensor ADXL345 (pedometer, flash message, hard disk drop protection...): iMEMS semiconductor technology integrates micro-mechanical structures and electronic circuits on the same chip. iMEMS accelerometers use this technology to measure single-axis, dual-axis, or even tri-; 雨中 ADI Reference Circuit

Based on AM335X development board ARM Cortex-A8——NAND FLASH version core board usage instructions: Preface: The usage of the NAND FLASH version and the eMMC version of the core board are basically the same. This article mainly describes the U-Boot compilation, basic device tree file compilation, NA; 别打牛牛 ARM Technology

I don't understand many formulas, and my head is buzzing.: How is the formula for the red line calculated? Why is the result 5.62A? I can't get this result no matter how I calculate it.; sky999 PCB Design

Continued from the previous post - MAGTROL HD-106-8NA-0100 dynamometer failure: The figure shows the fault display phenomenon of the control display DSP6001 of the MAGTROL HD-106-8NA-0100 dynamometer, which is over-range. The maximum range of the machine is 18mNm (about 183.78g.c; UUC Industrial Control Electronics

Why does the keilc debugger jump to a sub-function that has not been called when running the main function?: Why does the keilc debugger jump to a sub-function that has not been called when running the main function? After putting that sub-function in the main function, the main function will run to a part a; 一脸懵逼 MCU

A design about single chip microcomputer: The content is as follows: 1. Through the serial port, prompt the user to enter the countdown time (0~999 seconds); 2. After the time setting is completed, prompt the user to select the control mode:; kkhtkkht Embedded System

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号