• You can log in to your eeworld account to continue watching:
  • Memory image example
  • Login
  • Duration:4 minutes and 2 seconds
  • Date:2019/04/09
  • Uploader:抛砖引玉
Introduction
keywords: Linux STM32 Embedded
Embedded software design is a professional course in computer, software engineering and other disciplines. It is an important course with strong practicality and technical nature. The main task of this course is to comprehensively introduce GNU C language programming ideas and methods based on ARM/embedded Linux operating system, as well as embedded simulation technology based on STM32 processor and Proteus. Through the study of this course, students can master the basic processes and methods of embedded software design.

Unfold ↓

You Might Like

Recommended Posts

[Bluesun AB32VG1 RISC-V evaluation board] IDE installation and use
[i=s]This post was last edited by Beifang on 2021-8-9 14:03[/i]1. This board is perfectly compatible with rtthread studio. Follow the manual first, click multiple pictures, and click next. First downl
北方 Domestic Chip Exchange
It's New Year's Eve soon. I wish you all a happy New Year.
It's New Year's Eve soon, I wish you all a happy New Year :):)
music_586 Talking
【DIY Creative LED】Add touch button and install it on LED lamp
[i=s]This post was last edited by dcexpert on 2020-10-3 17:59[/i]The effect after installing the touch spring and fixing it with hot melt glue. When applying glue, use a USB cable to assist to avoid a
dcexpert MCU
[RISC-V MCU CH32V103 Review] - 2: Making an LED flash is not easy
[i=s]This post was last edited by MianQi on 2021-1-28 11:56[/i]Let's look at the wiring first (the tutorial says to directly connect PinA0\PinA1 and LED1\LED2 with jumpers. I'm not used to doing this,
MianQi Domestic Chip Exchange
SensorTile.box uses air pressure sensors to analyze environmental changes
After the SensorTile.box is flashed with DataLogExtended firmware, the sensor output data waveform can be directly viewed using Unicleo-GUI The following is the data obtained by using the air pressure
littleshrimp MEMS sensors
When using an oscilloscope probe to measure the AC waveform between the two ends of a component, how should the probe ground wire be connected?
When using an oscilloscope probe to measure the AC waveform between the two ends of a component, if the peak value of the AC voltage of the probe ground wire is 180V and the minimum value is -180V, th
深圳小花 MCU

Recommended Content

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号