• Duration:47 minutes and 28 seconds
  • Date:2018/07/05
  • Uploader:老白菜
Introduction
keywords: tcp ip
TCP/IP protocol is the abbreviation of Transmission Control Protocol/Internet Protocol. The Chinese translation is Transmission Control Protocol/Internet Protocol, also known as network communication protocol. It is the most basic protocol of the Internet and the basis of the Internet international network. It is composed of IP at the network layer. The protocol and transport layer are composed of the TCP protocol.
TCP/IP defines standards for how electronic devices connect to the Internet and how data is transferred between them. The protocol adopts a 4-layer hierarchical structure, and each layer calls the protocol provided by the next layer to complete its own needs. In layman's terms: TCP is responsible for discovering transmission problems, sending a signal when there is a problem, and requiring retransmission until all data is safely and correctly transmitted to the destination. IP assigns an address to every networking device on the Internet.
Unfold ↓

You Might Like

Recommended Posts

How to set stm32 counting to dual edge trigger mode
I don't know if it is possible to set the stm32 counting mode to dual edge trigger mode. If so, please tell me the method (C statement). Thank you!
若如 stm32/stm8
What is the fastest speed of the STM32 single-channel DAC?
For example, using a 72MHz clock, what is the shortest setup time for an analog signal? Thank you!
fsaok stm32/stm8
【DIY mobile phone】+ddllxxrr
[i=s]This post was last edited by ddllxxrr on 2014-5-16 12:12[/i] I want to use STM32F429I-Discovery, GSM module and audio input and output to realize a mobile phone solution. 1. Explain the function
ddllxxrr DIY/Open Source Hardware
Zhengdian Atom Elite STM32F103ZET6 Development Board Kit
[i=s] This post was last edited by lyg2275 on 2019-4-26 14:57 [/i] I work in analog electronics. I wanted to learn programming, but I never had the time. I never used it after I bought it. It has all
lyg2275 Buy&Sell
There is a program with a self-validation function. After changing it, the validation fails and it prompts invalid file.
I copied a program of Huawei switch to flash and changed the serial number inside. The file has automatic verification function, but it can't run. Is there any expert who can help me and give me some
shb316 ARM Technology
Problems with uDMA experiments
I am doing a uDMA experiment: The following sentence always prompts that it is not defined: ui32Status=ROM_UARTIntStatus(UART1_BASE,1); It prompts that the ROM_UARTIntStatus function is not defined. C
chenbingjy Microcontroller MCU

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号