• Duration:47 minutes and 17 seconds
  • Date:2018/07/05
  • Uploader:老白菜
Introduction
keywords: tcp ip
TCP/IP protocol is the abbreviation of Transmission Control Protocol/Internet Protocol. The Chinese translation is Transmission Control Protocol/Internet Protocol, also known as network communication protocol. It is the most basic protocol of the Internet and the basis of the Internet international network. It is composed of IP at the network layer. The protocol and transport layer are composed of the TCP protocol.
TCP/IP defines standards for how electronic devices connect to the Internet and how data is transferred between them. The protocol adopts a 4-layer hierarchical structure, and each layer calls the protocol provided by the next layer to complete its own needs. In layman's terms: TCP is responsible for discovering transmission problems, sending a signal when there is a problem, and requiring retransmission until all data is safely and correctly transmitted to the destination. IP assigns an address to every networking device on the Internet.
Unfold ↓

You Might Like

Recommended Posts

A question about programming
ORG 0000H LJMP START ORG 0030H START:CLR P0.4ACALL DELAYSETB P0.4ACALL DELAYAJMP START DELAY: MOV R7,#255 Y1: MOV R6,#255 DJNZ R6,$ DJNZ R7,Y1 RET END Always reports an error at the pin BASS.ASM(5): e
eeleader MCU
What do you think is the best time to discuss? [DIY Smart Home]
Please vote and we will discuss it at the most appropriate time. This will be more efficient.
soso DIY/Open Source Hardware
NI Webinar - How to Verify a Custom Design
The project you are working on is cutting-edge and unique, but there are few commercial off-the-shelf test solutions on the market that meet your needs. As your team must provide more services with li
eric_wang Motor Drive Control(Motor Control)
Highly recommended circuit simulation software (Part 2, Part 3)
Second. Ansoft Designer 2.2 (Electronic Electromagnetic Simulation): This is the latest complete version of Ansoft Designer v2.2, including Ansoft Designer 2.2 and Ansoft Nexxim 2.2. Ansoft Designer i
waterwj1984 PCB Design
The program can pass, but the puotues simulation cannot?
puotues file has been sent. #include reg51.h char XD[ ]={0x01,0x02,0x04,0x08,0x10,0x20,0x40,0x60};//x segment char code YD[] ={0xf7, 0xf7, 0xf7, 0xf7, 0xf7, 0xf7, 0xf7, 0xf7, 0xb7,0xab,0xa9,0x81,0xab,
wrlsohu 51mcu
C64x: Breakpoint Manager: Retrying with a AET breakpoint
This occurs during debugging, and the program itself has no breakpoints C64x: Breakpoint Manager: Retrying with a AET breakpoint C64x: Trouble Setting Breakpoint with the Action "Finish Auto Run" at 0
小子537 DSP and ARM Processors

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号