• Duration:46 minutes and 27 seconds
  • Date:2018/07/05
  • Uploader:老白菜
Introduction
keywords: tcp ip
TCP/IP protocol is the abbreviation of Transmission Control Protocol/Internet Protocol. The Chinese translation is Transmission Control Protocol/Internet Protocol, also known as network communication protocol. It is the most basic protocol of the Internet and the basis of the Internet international network. It is composed of IP at the network layer. The protocol and transport layer are composed of the TCP protocol.
TCP/IP defines standards for how electronic devices connect to the Internet and how data is transferred between them. The protocol adopts a 4-layer hierarchical structure, and each layer calls the protocol provided by the next layer to complete its own needs. In layman's terms: TCP is responsible for discovering transmission problems, sending a signal when there is a problem, and requiring retransmission until all data is safely and correctly transmitted to the destination. IP assigns an address to every networking device on the Internet.
Unfold ↓

You Might Like

Recommended Posts

Calculation of Resistor Thermal Noise
[font=Verdana]At any temperature above absolute 0° (-273°C or Ok), electrons in matter are in constant thermal motion. Since the direction of their motion is random, any short-term current is uncorrel
lixiaohai8211 Analog electronics
STC89C52RC Bluetooth module help
Is the STC89C52RC Bluetooth module connected to P30 and P31 or other pins... Cannot receive data... But the buzzer of the development board sounds
yadmek 51mcu
What are isolated digital inputs?
Although isolated digital inputs and digital isolators sound similar, there are actually some significant differences between them. After reading this article, hopefully you will be able to easily tel
qwqwqw2088 Analogue and Mixed Signal
Power supply design for next generation 48V distributed power architecture
In order to reduce the size of the power supply while retaining the compact brick model, power supply manufacturers must reduce the height of the brick module and ( or ) move the external power supply
feifei Power technology
[Help] Communication problem between 430 SPI interface and 74HC595
I use 430169 SPI bus to connect to 74HC595, there are 4 595s in total, they are cascaded.Data is displayed statically. Data received from asynchronous serial port is sent to 595 through SPI port for d
mdlv Microcontroller MCU
DDS (NCO) cordic based on coordinate shift transformation
The Verilog program of DDS written based on Cordic algorithm, with simulation program of Modelsim, is mainly written because I want to use CPLD to do DDS, but my CPLD resources are too few, only 570 L
luowhu Analogue and Mixed Signal

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号