5 Ways to Install LED Light Strips

　　1. The four-wire LED light strip has four wires, three rows of lights (note that it is not four rows of lights), 24 lights per row per meter, 24×3=72. Since the power of each lamp bead is 0.05W, the power of the 72-bead LED light strip is: 72×0.05=3.6W.

　　2. The width of the four-wire LED light strip is about 22mm, the thickness is about 8mm, and the weight is about 0.25kg/m (1 kilogram per 4 meters).

　　3. Each LED light strip must be equipped with a special plug (plug with transformer); when connecting, be sure to remove the transparent plastic cover, connect the test light and then cover it. Do not connect directly with the cover, as this will easily cause a short circuit!

　　4. Each meter has a "scissors" mark. You can only cut it at the mark. If you cut it wrong or off-center, it will result in a meter of waste! Some of them may be off-center when marking. It is best to carefully look at the position of the mark before cutting, and cut it at the place where there is no connection in the middle. You can see it if you look carefully.

　　5. When installing the LED light strip, you can usually put it in the light trough and straighten it. You can also use a thin rope or thin wire to fix it. If you need to install it outside or vertically, you need to purchase a clip and a tail plug separately. The original clip is fully transparent. It is best to apply waterproof glass glue on the tail plug and the plug after installation, so that the waterproof performance will be better.