Diodes Incorporated's 20Gbps multi-channel multiplexer/demultiplexer improves HD/UHD video signal routing efficiency
Plano, Texas, May 13, 2021 - Diodes Incorporated (Nasdaq: DIOD) has expanded its portfolio of passive video multiplexer/demultiplexer switches with the introduction of the 4-channel PI3WVR14412. This 2:1/1:2 multiplexer/demultiplexer device supports operating speeds up to 20Gbps, outperforming other products on the market and 35% faster than competitors.
PI3WVR14412 fully complies with the DisplayPort™ 2.0 and HDMI2.1 interface standards in the latest generation of graphics processor units (GPUs). Main product applications are mobile workstations, game consoles, docking systems, notebook computers, monitors, TVs and set-top boxes.
The PI3WVR14412 supports routing of 4K high-definition (HD) and 8K ultra-high-definition (UHD) video signals with minimal signal degradation from two sources to one receiver, or vice versa, from one source to two receivers.
Diodes Incorporated applied proprietary technology to increase the operating speed of the PI3WVR14412. The device's high-speed channels also maintain industry-leading signal integrity. When operating at a frequency of 10GHz, the insertion loss is -2dB and the return loss is -10dB. At this frequency, the channel-to-channel crosstalk is only -35dB and the off isolation is -15dB. The bit-to-bit skew is typically only 5ps.
Bidirectional communication is provided through the AUX channel. This means that other protocols such as USB 2.0 can be supported without additional wiring of the host, reducing the overall system cost. The wide input signal voltage range (0V to 3.6V) can directly couple HDMI under VDD bias and directly couple DP signals under 0 bias. Reducing the use of passive components also reduces the required space on the circuit board. Hot plug detection (HPD) and display data channel (DDC) are also added to save the need for an external multiplexer. The product also supports a wide temperature range of 0°C to 105°C.
These multiplexer/demultiplexer devices are available in a compact 40-pin TQFN package (3mm x 6mm x 0.75mm).
DisplayPort™ and the DisplayPort™ logo are trademarks of the Video Electronics Standards Association (VESA®) in the United States and other countries.
HDMI, High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing, LLC in the United States and/or other countries.
Previous article:UiPath DevCon to Hold Training Sessions to Drive RPA Innovation and Business Success
Next article:Siemens acquires Fractal Technologies to expand IC verification portfolio
Recommended ReadingLatest update time:2024-11-15 15:23
- Molex leverages SAP solutions to drive smart supply chain collaboration
- Pickering Launches New Future-Proof PXIe Single-Slot Controller for High-Performance Test and Measurement Applications
- CGD and Qorvo to jointly revolutionize motor control solutions
- Advanced gameplay, Harting takes your PCB board connection to a new level!
- Nidec Intelligent Motion is the first to launch an electric clutch ECU for two-wheeled vehicles
- Bosch and Tsinghua University renew cooperation agreement on artificial intelligence research to jointly promote the development of artificial intelligence in the industrial field
- GigaDevice unveils new MCU products, deeply unlocking industrial application scenarios with diversified products and solutions
- Advantech: Investing in Edge AI Innovation to Drive an Intelligent Future
- CGD and QORVO will revolutionize motor control solutions
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- Learn ARM development(14)
- Learn ARM development(15)
- Analysis of the application of several common contact parts in high-voltage connectors of new energy vehicles
- Wiring harness durability test and contact voltage drop test method
- From probes to power supplies, Tektronix is leading the way in comprehensive innovation in power electronics testing
- From probes to power supplies, Tektronix is leading the way in comprehensive innovation in power electronics testing
- Sn-doped CuO nanostructure-based ethanol gas sensor for real-time drunk driving detection in vehicles
- Design considerations for automotive battery wiring harness
- Do you know all the various motors commonly used in automotive electronics?
- What are the functions of the Internet of Vehicles? What are the uses and benefits of the Internet of Vehicles?
- BK3432 SDK Development and Use GuideBK3432 SDK Development and Use Guide
- Does anyone know where I can buy a mechanical switch like this?
- Should copper be applied to the ground under the inductor?
- LTC4368 overvoltage and undervoltage value calculation problem
- [NXP Rapid IoT Review] UART0 Debug Serial Port-Debug Print Demo
- Qorvo RF Fusion Successfully Adopted in Multiple New Smartphone Designs
- [Analog Electronics Course Selection Test] "Basics of Operational Amplifiers" course is over~
- EEWORLD University Hall----Live Replay: Flyback Isolation Power Supply Design Without Optocoupler
- Help with LCD character set
- [GD32E503 Review] Snake Program Running