Use of logic analyzer in analysis

1. Do not use parsing function

After the logic analyzer captures the signal, if we do not use the parsing function, we can also read the code by reading 01, but it is very troublesome, especially for 8-16bit data.

2. Use the parsing function

We can add bus methods in the parser, but the prerequisite is that we need to know which bus we are communicating through.

Here I use a single bus method, you can see obvious initialization and reply pulses, and the parser annotates each code segment;

This seems more intuitive.

3. View after analysis

In addition, all the codes are listed in order:

We can see that all data types start with 0x:

In fact, the parsed data is expressed in hexadecimal: