After testing, it was found that the RF front-end mixer was faulty, resulting in no signal detection and self-calibration error.
Repair process
The damaged components were replaced and the engineers adjusted the indicators.
Repair results
The instrument self-test is normal, the test signal is normal, and the repair is completed.
Previous article:Network analyzer maintenance--Precautions for daily use of network analyzer
Next article:Spectrum Analyzer Maintenance--N9030A Startup Error Failure Case
- Popular Resources
- Popular amplifiers
- Seizing the Opportunities in the Chinese Application Market: NI's Challenges and Answers
- Tektronix Launches Breakthrough Power Measurement Tools to Accelerate Innovation as Global Electrification Accelerates
- Not all oscilloscopes are created equal: Why ADCs and low noise floor matter
- Enable TekHSI high-speed interface function to accelerate the remote transmission of waveform data
- How to measure the quality of soft start thyristor
- How to use a multimeter to judge whether a soft starter is good or bad
- What are the advantages and disadvantages of non-contact temperature sensors?
- In what situations are non-contact temperature sensors widely used?
- How non-contact temperature sensors measure internal temperature
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
- Why software-defined vehicles transform cars from tools into living spaces
- How Lucid is overtaking Tesla with smaller motors
- Wi-Fi 8 specification is on the way: 2.4/5/6GHz triple-band operation
- Wi-Fi 8 specification is on the way: 2.4/5/6GHz triple-band operation
- Vietnam's chip packaging and testing business is growing, and supply-side fragmentation is splitting the market
- Vietnam's chip packaging and testing business is growing, and supply-side fragmentation is splitting the market
- Three steps to govern hybrid multicloud environments
- Three steps to govern hybrid multicloud environments
- Microchip Accelerates Real-Time Edge AI Deployment with NVIDIA Holoscan Platform
- Microchip Accelerates Real-Time Edge AI Deployment with NVIDIA Holoscan Platform
- Mobile station update development board, welcome to borrow it!!
- 3. "Wanli" Raspberry Pi car - Python learning (timing task)
- This is a camera development board, but where is the camera?
- Sharing the principle of the adapter solution for charging while listening to music
- Make announces its return
- The mysterious EMC, how did it come about?
- EEWORLD University - Zero-based circuit learning
- Appointment viewing double gift: How to ensure edge computing security? Learn about an important tool
- [Sipeed LicheeRV 86 Panel Review] 6-socket to achieve communication between different processes
- Usage diagram of various Arduino basic components