Combination of source ground and emitter follower
Source: InternetPublisher:super_star Keywords: Ground emitter follower transistor amplifier Updated: 2021/08/12
Combination of source ground and emitter follower
The combination of source ground and emitter and collector (common collector transistor amplifier ). As shown in the figure, VTI is a grounded oscillator field
effect tube amplifier, and VI2 is a common collector transistor amplifier . If vn is not set in the circuit, but the load
RL of several thousand ohms is directly used as the load of VT1, the voltage gain will be quite small. By combining it with an emitter follower with low output impedance ,
a higher voltage can be obtained Gain, which is the main characteristic of this circuit.
- What is power factor and three ways to improve it
- Make a flameless electronic candle using simple electronics and LEDs
- What is a Demultiplexer
- Square wave frequency multiplier (SN15844N, SN7400N)
- Phase-locked Frequency Multiplier(9316)
- Digital control frequency division circuit composed of MC4018
- Frequency divider composed of TTL decade counter
- Odd-frequency counter with symmetrical output waveform (SN7474, SN74163)
- Homemade Simple Frequency Synthesis Signal Source
- Design circuit of voltage inverter using PWM
- Four connection methods and characteristics comparison of differential amplifier circuitd
- Computer system professional ground wire and dedicated conversion socket wiring
- Wiring a when the leakage protector in the TT system is used for single-phase load
- Adjustable voltage stabilizing circuit
- LM621 brushless DC motor commutation circuit-three-phase half-wave drive circuit
- Making an entry-level tube amp
- Different grounding system circuit diagrams for different power systems
- Ground tester circuit diagram
- High current NOT gate driving a grounded load
- Motor security grounding circuit diagram
京公网安备 11010802033920号