How multi-resonators worka
Source: InternetPublisher:红水杯 Keywords: Resonator BSP switch Updated: 2021/04/14
Astable multivibrators are widely used in electronic equipment and are widely used in pulse signal generation circuits. Its working principle is
shown in Figure 17-18. As can be seen from the figure, the two transistors VT1 and VT2 are connected by coupling circuit A in the form of C2 and Rz. The output of VT2
is sent to the input end of VT1 through the coupling circuit B (C,, R,) to form positive feedback, thus forming an oscillator circuit. Replace
the transistor VT1 in the figure with a switch Sl, and omit the coupling circuit B (Ci, Rl) from VT2 to VT1, and it
becomes the figure.
Figure (a) shows the situation when switch sl is turned off. Positive voltage is added to the base of VT2 from the power supply through R2 , causing V-12 to conduct. At this time,
the dotted line in the circuit is the current charging capacitor C2.
Then make the switch sl close t as shown in figure (b). Since the capacitor C2 has been charged at this time, the voltage is reduced to o. Therefore, at the moment when the switch is closed,
it is equivalent to adding negative voltage to the base of VT2, causing VT2 to cut off. The direction of the dotted line in Figure (b) is the direction in which the charge of capacitor c7 is discharged.
Then the base voltage of VT2 changes from negative to positive, and then VT2 is turned on again.
- What are the main types of resistors? Detailed explanation of the functions and uses of resistors
- How does sand become chips?
- Advantages and disadvantages of organic semiconductors, the conductive mechanism of organic semiconductors
- How to calculate the value of capacitors in parallel?
- Working principle and truth table of JK flip-flop
- Tutorial on building a NOT gate using BJT transistors
- Experimental circuit based on 4040 binary adder counter
- Circuit diagram of a differential amplifier circuit
- FL52C4 induction electronic greeter
- Frequency divider that converts 50Hz or 60Hz frequency into 1/60 frequency (CD4040)
- Electronic thermometer circuit
- Homemade disinfectant circuit
- Greenhouse temperature control circuit
- Soil water shortage prompt circuit
- Diode balanced amplitude modulation circuit
- Multi-frequency resonant high-frequency power amplifier circuit for transmitter stage
- Differential Amplifier Circuit
- Voltage-controlled voltage source second-order band-pass filter circuit
- Power phase sequence display circuit
- Digital stopwatch display circuit