CMOS line receiver
Source: InternetPublisher:张小哥 Keywords: Power supply other power circuits Updated: 2021/06/24
The trip point is set halfway between the R1 and R2 supplies; R3 provides over 200mV of hold-up for enhanced noise immunity. The maximum frequency of operation is approximately 300kHz. If TTL level feedback is required, change R2 to 39K. The trigger point is centered at 1.4V.
Latest Power Circuits Circuits
- How to improve the accuracy and precision of power supplies through low frequency thermal noise?
- How about the boost converter TPS61299?
- 5 Converter Topologies for Integrated Solar and Storage Systems
- Benefits of Wide Bandgap Technology for Power Converters
- Driving circuit of switching power supply field effect tube
- Driving circuit that controls LED brightness using PWM signal
- Simple and practical LED lamp driving circuit
- A simple positive and negative power supply circuit
- Design of electric vehicle charger
- Reconstruction of the tube pre-stage by using low voltage difference power supply
Popular Circuits
- Analysis on solving various electromagnetic interference problems of electronic equipment
- How to turn on the power with LLC controller?
- Determining the prerequisites for successful circuit board design
- Maintenance skills and common faults of switching power supply
- About the working principle of single touch mode light switch
- Design of data transmission interface circuit for a car driving recorder
- SKiiPPACK unit circuit
- An operational amplifier with very high amplification
- mini stereo amplifier
- Clock switching circuit and its precautions
京公网安备 11010802033920号