[Repair] Repaired a data cable

吾妻思萌

[Repair] Repaired a data cable [Copy link]

 

 

Recently, a 5A USB port was loose, so I fixed it based on the idea that electronic engineers should do more hands-on work (poor, no money, can't bear to throw it away). The effect is quite satisfactory, but there is still one last step.

Finally, the welding is done. All that’s left is to glue it together or put on a heat shrink tube.

lugl4313820

Some data cables have chips inside, doesn't this one?

qwqwqw2088

The welding technology needs to be provided. There are a lot of burrs between the solder joints.

littleshrimp

It is not enough to just put on the heat shrink tube, you need to glue it inside

ddllxxrr

This can also be repaired, you are an ass

吾妻思萌

qwqwqw2088 posted on 2022-7-29 07:35 I need to provide some welding technology. There are a lot of burrs between the solder joints

Yes~ The last time I touched a soldering iron was the last time.

I haven't touched a soldering iron for a long time. My hands are so useless.

But I tested it with a multimeter and it was not shorted.

吾妻思萌

ddllxxrr posted on 2022-7-29 08:10 This can also be fixed, you are an ass

That's what poor people do. If you don't have money, you have to think about repairing it~~~

吾妻思萌

littleshrimp posted on 2022-7-29 07:56 Just putting on the heat shrink tube is not enough, you need to use glue to fix it inside

Do you have any recommended glue? I feel like the space in the middle is super small. Should I dig a little first and then add glue?

Need some advice~~~

dcexpert

Generally, in this case, it is easy to break even after repair. It is better to replace it. There are many data cables with free shipping for a few yuan.

littleshrimp

Azuma Si Meng published on 2022-7-29 08:22 Do you have any recommended glue? I think the space in the middle is super small. Should I dig a little before adding glue? I need some advice~~~

Brothers, AB glue should be about the same

freebsder

Need glue or heat shrink tubing? As a poor man, shouldn't I use a soldering iron to melt the rubber on the wire and apply it on?

476700838

You know so much! You are so knowledgeable! We all need to learn from you!

476700838

Success belongs to the most powerful people. Here, "power" refers to culture, knowledge, ability,

wangerxian

I applied some hot melt glue, but it doesn't seem to last long. The data cable has reached the end of its life.

niuyite

Very cool! I admire you!

吾妻思萌

lugl4313820 posted on 2022-7-29 06:00 Some data cables have chips in them, does this one not?

High-end ones have chips, but the hype is greater than the practical significance

吾妻思萌

freebsder posted on 2022-7-29 10:11 Do you need glue or heat shrink tubing? As a poor person, shouldn't I use a soldering iron to melt the rubber on the wire and apply it on?

The rubber is hard to shape, so it is cut flat.

吾妻思萌

wangerxian posted on 2022-7-29 11:12 I applied some hot melt glue, but I don't think it will last long. The data cable has reached the end of its life.

I feel like it can be used for a long time, the 5A wire diameter is OK

秦天qintian0303

You can buy a new plastic part, it will look better and it is also cheap.

15874096935

666