Anlu SparkRoad Development Board Unboxing Review

冒险武者

Anlu SparkRoad Development Board Unboxing Review [Copy link]

 

I received the board during the Qingming Festival, and I just added the unpacking stickers now. I was shocked when I received the board. The board was protected by two non-transparent acrylic plates, and the circuit could not be opened at all. This is the first time I have encountered such a situation.

I don't know if I installed the acrylic sheet wrong.

Later, I removed a few studs by myself, and finally saw the front of Mount Lushan.

When I saw the bottom, I was surprised that the ESP32 chip was not soldered, which was a big pity for the board.

At first glance, the board is low-end, but as a test board, it has quite complete basic functions. Function is king in the market.

A small suggestion: Next time, you can reserve four pins of the four JTAG pins to facilitate jumpering to other Anlu FPGA JTAG loading and debugging.

littleshrimp

Do you see if there is an opaque film on the acrylic that has not been removed?

littleshrimp

I think this board has good hardware.

冒险武者

littleshrimp posted on 2022-4-10 22:27 I think this board has good hardware

It is confirmed that there is no film. The single board is still good, mainly because it has a reserved Arduino interface, which makes it convenient to play with.

littleshrimp

Adventure Warrior published on 2022-4-10 22:35 It is confirmed that there is no film. The single board is still good. The main thing is that the Arduino interface is reserved, which makes it convenient to play.

The panel of my board is transparent. When I removed the acrylic, I found a small piece of translucent film under the screw.

lugl4313820

They are all successful FPGA players. I’m so envious!