containsmachine

ESP32-S3 development board

 
Overview

Development board based on ESP32-S3-WROOM-1-N8R2.
I have a few ESP32S3 modules on hand, ready to be made into development boards, so I’ll send them out by the way.
 
9.9 The verification is done and the verification is successful.
  Well, the verification was successful. The serial port chip used this time is CP2102GMR, and the power supply is the high-efficiency low-ripple BUCK solution of MPM3810. After all, the power consumption of ESP32-S3 is not small.
       (The stress test was completed on September 10th. The full-brightness RGB light and Bluetooth were turned on for a long time. The ESP32-S3 module was warm. The MP3810 was at the same temperature as the board and no heat was felt.)
  There are two indicator lights on the entire development board, one is the MPM3810 The POWER GOOD indicator light also uses a WS2812 RGB lamp bead as the onboard program indicator light, and the DATA connection is IO48.
  Below is a demonstration video of it working.
  
 
 
 
参考设计图片
×
 
 
Search Datasheet?

Supported by EEWorld Datasheet

Forum More
Update:2024-11-14 23:40:50

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京ICP证060456号 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号