Looking for a board-to-board connector model

littleshrimp

Looking for a board-to-board connector model [Copy link]

This is the connector on the Valeo LiDAR that I disassembled last time . The world's first automotive LiDAR , the connector is 10*2pin with a pin spacing of about 0.8mm. I found many similar ones on the Internet, but they are all different. This feature is that the spacing between the pins in the middle is larger than that of the other pins.

btty038

Is this phone used more often?

littleshrimp

btty038 posted on 2022-3-25 12:32 Is this phone used more often?

It should be something like a camera or a display.

littleshrimp

btty038 posted on 2022-3-25 12:32 Is this phone used more often?

The strange thing about it is that there is a metal sheet on the left side of the first picture connected to the left edge of the PCB.

littleshrimp

I think it might be from MOLEX, but I can't find it on Mouser, and I can't access the product page on the Molex official website.

btty038

littleshrimp posted on 2022-3-25 12:40 The strange thing about it is that there is a metal piece on the left side of the first picture connected to the left edge of the PCB.

It is used for reinforcement testing. You need to open it during testing to avoid damaging the socket.

btty038

btty038 posted on 2022-3-25 12:43 It is used for reinforcement testing. It needs to be opened during testing to avoid damage to the seat

TE or Molex connectors are probably available. Haven't seen the product manual for a long time? Now suppliers are starting to go the custom route.