PCB error cannot find the cause

呜呼哀哉

PCB error cannot find the cause [Copy link]

This line in this PCB interferes with itself. The left and right spacing is 11.38mil, so there shouldn't be any problems. Does anyone know the reason? I have obsessive-compulsive disorder and I'm upset if the error is not 0.

EricCheng

Delete it and see it in the cloth

okhxyyo

Delete this line and practice again. Check it out. There may be some thread ends covered by this line. Check carefully to see if there are any extra small dots.

呜呼哀哉

okhxyyo posted on 2021-2-4 10:35 Delete this line and practice again. Check it out. There may be thread ends covered by this line. Check carefully to see if there are any extra small dots

This was done in AD9. I selected all using CTRL+H and tried again, but it didn't work.

okhxyyo

Then you can check if the network is correct. It may be due to cracking. Sometimes the line segment drawn is missing the network or the network is wrong. You can check if the network is correct by clicking on tab.

annysky2012

After you delete this line, redraw it. Then check the rules