Single point grounding, DRC error

刘木木

Single point grounding, DRC error [Copy link]

After the different ground GND and AGND are connected at a single point, it is easy to cause the copper to be re-clad and the single point to be disconnected. If the DRC prompt is not disconnected, how can this problem be avoided?

qwqwqw2088

Add a 0 ohm resistor or a magnetic bead connection

曹伟1993

Use a 0 ohm resistor or ferrite bead for single point grounding so it won't get disconnected and you won't forget to connect it