手可摘棉花

Open source USB PD powered mini SMD reflow heating plate

Overview

This is a DIY, low-cost PD powered reflow soldering heating plate that uses a cermet heater (MCH) instead of a PCB heating plate for heating. It has a USB Type C input port and can be powered by a 20V 3A 60W (65W) PD power supply. This heating plate can automatically reflow solder pastes in the mid-temperature range, such as Sn63Pb37. What you need is to hold down the "Start" button for 5 seconds and wait for the reflow process to complete. Features USB Type-C PD powered (no special power adapter or dangerous AC power required) Economical and high quality heating element (replaces PCB heating plate) Open Source Fully automatic, just hold "START" and wait for reflow to complete

Design Files

Schematic, PCB, firmware, etc.

All reference designs on this site are sourced from major semiconductor manufacturers or collected online for learning and research. The copyright belongs to the semiconductor manufacturer or the original author. If you believe that the reference design of this site infringes upon your relevant rights and interests, please send us a rights notice. As a neutral platform service provider, we will take measures to delete the relevant content in accordance with relevant laws after receiving the relevant notice from the rights holder. Please send relevant notifications to email: bbs_service@eeworld.com.cn.

It is your responsibility to test the circuit yourself and determine its suitability for you. EEWorld will not be liable for direct, indirect, special, incidental, consequential or punitive damages arising from any cause or anything connected to any reference design used.

Hot

Technical Resources More

Search Datasheet?

Supported by EEWorld Datasheet

Technical Videos More

Forum More

Update:2024-11-13 23:45:25

Differences between JTAG, SBW, and BSL interfaces of MSP430 programmer emulator
For MSP430, simulation and programming can generally be done through the JTAG, SBW, and BSL interfaces. JTAG and SBW interfaces can be used for simulation, but BSL interfaces cannot be used for simula
i.MX6ULL development board thread synchronization POSIX unnamed semaphore
To ensure that each thread has valid access to the same resource, for example, if a thread wants to read data from a shared resource, and these resources are being modified by other threads, then the
Introduction to the method of board-level online compilation and downloading of C6000 DSP code
[align=left][color=rgb(85, 85, 85)][font="][size=4]The performance of ARM processors is increasing day by day. In many applications, there will be ARM+DSP solutions in the system. This paper proposes
T6963C displays garbled characters
I use STM32F103 to drive the T6963C screen to display numbers and Chinese characters, but garbled characters appear, which is very annoying. program: //--------------------------------------------- //
[Construction Monitoring and Security System] 6. Kaluga's adc_button case combined with lvgl
This article will use the lv_port_esp32 case as a template, plus Kaluga's adc_button case - button control of RGB multi-color light changes. 1. Kaluga's onboard buttons and LEDs Kaluga has six buttons
CCS5.5 compiles the project and always prompts an error, see the following figure
I can't find the reason, please help me

Datasheet More

Circuits More