Plastic sealing machine circuit diagram
Source: InternetPublisher:兰博 Keywords: Relay Updated: 2024/10/15
When K1 is just turned on, KZ is powered on and works. Since the voltage of C2 is very low, BG is not conducting and the relay is energized. When C2 is charged to a certain level, BG is conducting, SCR is conducting, the relay power-off contact is disconnected, and heating stops. After K1 is disconnected, the power on C2 is discharged through D2, and the next cycle is ready. Adjusting W can change the working time of the sealing machine. In order to improve the reliability of the circuit, D3 increases the BG emitter voltage.
- Electronic Rat Killer Circuit
- Working Principle and Production of TV Scanning Demonstrator
- Making an Off-Grid Solar PV System
- Bookcase moth-proofing circuit made with 7556 dual-time base circuit
- How to build an internet-connected traffic meter
- Introducing a common reversing radar-----Ultrasonic detector
- DIY a temperature and humidity monitoring system
- Water level control circuit using automobile spark plugs
- Mining winding hoist anti-loosening rope protection circuit
- Z32A, Z32K, Z3025J radial drilling machine electrical schematic circuit
- Power outage alarm circuit
- Random password keyboard circuit
- Timing circuit that prohibits restarting
- Relay fixed time overcurrent protection circuit a
- Relay power saving circuit 4b
- Interface circuit between power supply coupler and relay
- One of the temperature switch circuits
- Reed relay spark elimination circuit
- Use low operating voltage relays for mains circuits a
- Economical relay circuit 2