1856 views|4 replies

3222

Posts

0

Resources
The OP
 

Problems encountered with diode step-down [Copy link]

Problems encountered with diode step-down

二极管降压.png (35.72 KB, downloads: 1)

二极管降压.png
This post is from Discrete Device

Latest reply

Just connect a dummy load, such as a 10K resistor to J0 or J8.  Details Published on 2020-11-30 13:46
 
 

2w

Posts

0

Resources
2
 

First, determine whether there are other electrical devices at J8. If there are no electrical devices at J8, use the same multimeter to measure the voltage at the point marked as 5V in the diagram to see if it is correct.

This post is from Discrete Device

Comments

I connected them all separately. How could there be other electrical devices?  Details Published on 2020-11-30 12:09
 
 
 

3222

Posts

0

Resources
3
 
maychang posted on 2020-11-30 11:56 First, determine whether there are other electrical devices at J8. If there are no electrical devices at J8, use the same multimeter to measure the point marked as 5V in the diagram...

I connected them all separately. How could there be other electrical devices?

This post is from Discrete Device
 
 
 

1127

Posts

17

Resources
4
 
Just connect a dummy load, such as a 10K resistor to J0 or J8.
This post is from Discrete Device

Comments

It must have a load, right?  Details Published on 2020-12-1 11:50
 
 
 

3222

Posts

0

Resources
5
 
fxyc87 posted on 2020-11-30 13:46 Just connect a dummy load, such as a 10K resistor to J0 or J8,

It must have a load, right?

This post is from Discrete Device
 
 
 

Guess Your Favourite
Just looking around
Find a datasheet?

EEWorld Datasheet Technical Support

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号
快速回复 返回顶部 Return list