• Duration:10 minutes and 6 seconds
  • Date:2023/10/28
  • Uploader:Lemontree
Introduction
keywords: radio frequency antenna
Phased array antenna refers to an antenna that changes the pattern shape by controlling the feed phase of the radiating units in the array antenna. It is an area array composed of a large number of identical radiating units. Each radiating unit is independently wave-controlled in phase and amplitude. and phase shifter control to obtain accurate and predictable radiation patterns for beam control and scanning. Phased array is mainly composed of three parts: antenna array element, wave control network and power divider. Its technology involves radio frequency transceiver system, amplifier, filter, phase shifter, power divider, antenna design, micro-assembly process, etc. Therefore, , phased array design technology can be called the "ceiling-level" technology in the microwave field.

1. Phased array principle and core technology;

2. Wave control network (TR component) architecture and core technology;

3. Phased array element type, structure and design technology;

4. Phased array antenna assembly process.
Unfold ↓

You Might Like

Recommended Posts

How to know the id of i2c slave device
Hi, everyone, on our device, there is an encryption chip connected to the i2c bus. Now I am writing the driver for the encryption chip. When calling the i2c protocol driver interface, I need to specif
foxyboss Embedded System
Image Compression Using ADV202/ADV212
I have worked in Beijing for more than 6 years, specializing in FPGA peripheral interface design, and am very familiar with JPEG2000 and using ADV202/ADV212 for image compression.Very familiar with AD
axpro FPGA/CPLD
How to operate and configure vc2005 to develop embedded database (access), PC side and device side
How to operate and configure the embedded database (access) developed by vc2005, PC and device expert guidance
benson Embedded System
Regarding the problems encountered when using SIM800C, please help
When using sim800c to send text messages, I only know how to send a series of data, but I can't do it if I want to split it into lines. For example: Device number: 00 Pressure abnormality! How can I a
ena stm32/stm8
【IMMC-DIY Laser Engraving Machine】-Version 0.7 Test Prototype Assembly-No. 01
The stuff has basically arrived. I started assembling it these two days. Since I have been busy recently, I expect it to be done in about 3 days:) [size=14px]1. Acrylic board: After the board is assem
kejoy DIY/Open Source Hardware
Help: Using TOP224 to make a switching power supply
[i=s] This post was last edited by paulhyde on 2014-9-15 09:52 [/i] The production requirement is to use TOP224 to make a switching power supply with an output of 24v and a power of 20W. If anyone has
321475 Electronics Design Contest

Recommended Content

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号