(1) Open the reservoir cover and inject new brake fluid into the reservoir until the liquid level reaches the maximum liquid level mark (the "(2) If the brake system has just been repaired, or if the
The actual circuit is this, where r1=160k, r2=16M, c1 is 1nf, c2 is 1pf. The blue is the input test sine wave 5v Vpp 12hz, and the yellow output is distorted at this time. When the input is 11hz, ther
Last week, I posted a thread to solicit opinions, and everyone gave a lot of good suggestions. However, many opinions are from a general direction, and few are specific, so I hope everyone can give so
Environment: JFlash SWD mode, three-wire SCLK SDIO GND Atmel SAMD10D14AM Problem 1, JFlash can connect to SAMD10, but the burning will probably fail. The error reported is “Can not read register 20 (C
Last weekend, I did a new comparison of pi calculations, comparing the performance of different processors by calculating pi with different digits. In addition to MicroPython, I also did a comparison