• Duration:19 minutes and 37 seconds
  • Date:2022/11/20
  • Uploader:EE大学堂
Introduction
keywords: FPGA
This series of videos is a step-by-step introduction to the DFPGL22G development board. It is suitable for the majority of student users and electronic engineers to get started and improve FPGA development. The DFPGL22G development board is the first board based on domestic FPGA chips launched by Zhengdian Atom. The main control chip uses PGL22G from Unisoc’s Logos series. It is a very cost-effective chip among Unisoc’s FPGA chips.
Unfold ↓

You Might Like

Recommended Posts

Development process of eCAN in DSP28335
I used the CAN bus of DSP28335 for some time. In fact, I have almost understood the basic principles of CAN bus, but there are still some problems in the process of configuring 28335. 1. About TI rout
Aguilera DSP and ARM Processors
When downloading the program using flash magic on LPC811, the device ID cannot be read. Why?
I have recently been developing with a small board based on lpc811, but I have encountered a problem where I cannot download the program using flash magic, and I cannot read the device ID either. I wo
风哥哥 NXP MCU
Sugar gliders Part ⑩ Sugar glider health monitoring system based on RSL10 - host computer design
Preface The goals of this project are introduced in the project introduction post, the second and third of which are : 2. Sports and health data analysis: Since Xiao Mi is active at night, when we are
justd0 onsemi and Avnet IoT Innovation Design Competition
DSP Technology and Application
sdjntl DSP and ARM Processors
[Repost] Please don’t be an impetuous embedded system engineer
Copying a post from the Internet: 1. Don't say "Give me a code!" as the first sentence after seeing someone's reply. You should think about why. When you figure it out yourself and refer to other peop
gjidfo Embedded System
Can someone help me figure out whether this active filter is a voltage-controlled power supply type or a multiple feedback type?
Can someone help me check if this active filter is a voltage-controlled power supply type or a multiple feedback type? Also, if I want to change it to a low-pass filter with a cutoff frequency of 1kHz
南木木 Analog electronics

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号