I had some time to solder the board today. I used a 0.33R current sampling resistor because I only have this one. I used a 2K resistor for the CSO pin. I used an external resistor to set the voltage t
Based on the principle of orthogonal up-conversion modulation, a new method of frequency signal generation is proposed to address some shortcomings of DDS (direct digital frequency synthesis) excitati
This work designs and implements a non-contact sensing current signal detection device. The peak-to-peak value of the current passing through the load resistor is increased to above 1A through the pow
Help me, this happens when I place a pad. I searched and it said to not select a slot and select a round one, but it is grayed out and I can't select it.
What should I do? Thank you!
[i=s]This post was last edited by mig29 on 2020-11-6 20:47[/i]This article is mainly used as a memo note: confirm that the USB Composite_Device Demo of Artery is easy to use and has a good program str
[Abstract] Great Wolf Resorts in the United States has introduced an RFID wristband system. After customers wear the RFID wristband, they can open their room doors and pay for purchases in the activit