[align=left][color=rgb(51, 51, 51)][font="][size=14px] When receiving users, we will encounter some problems more or less. The most common user consultation is about the speed of plate making and whet
I had some time to solder the board today. I used a 0.33R current sampling resistor because I only have this one. I used a 2K resistor for the CSO pin. I used an external resistor to set the voltage t
Based on the principle of orthogonal up-conversion modulation, a new method of frequency signal generation is proposed to address some shortcomings of DDS (direct digital frequency synthesis) excitati
This work designs and implements a non-contact sensing current signal detection device. The peak-to-peak value of the current passing through the load resistor is increased to above 1A through the pow
Help me, this happens when I place a pad. I searched and it said to not select a slot and select a round one, but it is grayed out and I can't select it.
What should I do? Thank you!
[i=s]This post was last edited by mig29 on 2020-11-6 20:47[/i]This article is mainly used as a memo note: confirm that the USB Composite_Device Demo of Artery is easy to use and has a good program str