• Duration:52 minutes and 26 seconds
  • Date:2019/11/29
  • Uploader:抛砖引玉
Introduction
The hardware structure and instruction system of the MCS-51 microcontroller are introduced in detail. From the application perspective, the assembly language programming and various hardware interface designs, various commonly used data operations and processing programs, interface drivers and the MCS-51 microcontroller are introduced. The design of the application system and the anti-interference technology and various new devices in the design of the MCS-51 microcontroller application system are also introduced in detail. This book highlights the practicality and typicality of the selected content. Most of the application examples in the book come from scientific research work and teaching practice, and have been tested and are rich and detailed.
Unfold ↓

You Might Like

Recommended Posts

How to connect multiple locations together
I am a newbie in analog electronics. I am using TI's xtr300 recently. The manual says there are 2 analog grounds and 2 digital grounds. As shown in the figure below, are the two analog grounds GND1 an
宅男745363663 Analogue and Mixed Signal
An important question from swine flu
From bird flu to swine flu, it shows: Are we getting closer to animals or are animals getting closer to humans? :loveliness:
shicong Talking
Please advise on initializing erase of P33
In the BSP of PXA270, is there such a code for the Erase operation of FLASH--P33(64M): [b]if [/b]( ((flashType == L18) || (flashType == L30) || (flashType == P33))&& (num_l3_blocks_erased > 0) ) { //
alan_zhang Embedded System
Please help me answer
Since the battery voltage is 24V when fully charged, it will decrease as the battery is used, but the output is required to be 5V, and the output power is required to be relatively large. How to build
1142688779 Analogue and Mixed Signal
Practical Considerations for Amplifier Compensation
There are many practical considerations when compensating an amplifier to get the fastest settling time (see Figure 1 in the text). Once an amplifier is selected, the only stability variable that can
Aguilera Analogue and Mixed Signal
UART Interrupts
How to use UART interrupt to send data? I used to assign value to UCA1TXBUF in the main program and send it, which was fine. But the interrupt does not work. Please give me some advice. The routine gi
zzbaizhi Microcontroller MCU

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号