Training

Location:Training / Circuit Fundamentals / Mechanics in Electronic Packaging / Mechanics in Electronic Packaging (12)

You can log in to your eeworld account to continue watching：
Mechanics in Electronic Packaging (12)
Login

Duration：18 minutes and 35 seconds
Date：2019/06/29

Uploader：木犯001号

Introduction

keywords： Electronic Packaging Mechanics

Modeling, simulation and cutting mechanics analysis in precision machining (Lecturer: Professor Cheng Kai)
Mechanical issues in electronic packaging (Lecturer: Professor Liu Sheng)
Surface and interface physical mechanics in nano-micro systems - experiments, cross-scale Simulation and theoretical modeling (Lecturer: Researcher Zhao Yapu)
Basic theories and methods of optimal design of advanced lightweight structures (Lecturer: Professor Zhang Weihong)
From "forming" processing to surface integrity and fatigue-resistant manufacturing (Lecturer: Professor Zhang Dinghua)
Micro Scale plastic mechanics and cross-scale correlation (Lecturer: Professor Li Zhenhuan)

You Might Like

Recommended Posts

CMOS Sensor strange problem: Using S3C2440 to drive Micron CMOS Sensor. Covering the CMOS window with a black cloth, when the CMOS sensor size is set to 640×320, the data obtained in the memory is close to 0. But when the size is; youngboy Embedded System

After returning from the competition, I share my experiences and thoughts, and attach all the source code I made in m3: The competition is back. Please forgive me. It has been so long since I came to report to the forum. I have many feelings about this competition. I want to say a few words here.On September 14, 2009,; zhengjiewen Microcontroller MCU

TI's high voltage op amp (power amplifier): [i=s] This post was last edited by dontium on 2015-1-23 11:32 [/i] :) OPA445: can work under +-45V power supply; This voltage is a bit low. It is the highest working voltage op amp of TI that I know.; music_586 Analogue and Mixed Signal

Problems with AND gate design: I use SN74LVC1G08 single AND gate chip, connect the circuit as shown in the figure, the pulse signal input to the 2nd pin of the MCU is 3.3V, why is the output signal amplitude of the 4th pin only 0.5; EagleHawk FPGA/CPLD

Hello everyone, I am currently working on my graduation project. Can anyone help me translate a foreign language article about microcontrollers?: Hello everyone, I am currently working on my graduation project. Can anyone help me translate a foreign language article about microcontrollers? It can be all in English, I can translate it myself.; lcyviceboy1 Embedded System

[Perf-V Review] + Issues to note when installing Perf-V IDE: I originally planned to use Perf-V IDE as the development tool for the Perf-V development board, but after installing the driver on two computers at home, both were not in normal status, so I can only; jinglixixi FPGA/CPLD

Recommended Content

Hot VideosMore

Hot ArticlesMore

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews

Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函

京公网安备 11010802033920号