• Duration:46 minutes and 30 seconds
  • Date:2019/06/13
  • Uploader:老白菜
Introduction
keywords: parallel computing
Parallel computing is one of the core contents in the parallel algorithm teaching system. It is the basic level of algorithm application in the parallel algorithm teaching system. It is aimed at senior undergraduate students majoring in computer science or graduate students engaged in computing science. It is designed to adapt to high-level students. The rapid development of high-performance computers meets the country's needs for cultivating high-tech talents for the 21st century. To this end, this course strives to be innovative in its content system. While following the course's own discipline, systematization, and completeness, it should fully consider the needs of solving large-scale scientific engineering problems on parallel computers in different application fields, and combine parallel computers with The contents of courses such as architecture, parallel numerical computing, parallel algorithms and parallel programming are organically integrated to form a new type of parallel computing course in China.
Unfold ↓

You Might Like

Recommended Posts

TI C2000 kit DRV8301-69M-KIT running instaSPIN-MOTION problem
Hello everyone, is it necessary to use a position sensor when running instaSPIN-MOTION on the DRV8301-69M-KIT? However, when I look at the GUI interface and want to adjust the PMSM motor to run in mot
wkei007 Microcontroller MCU
What does the two quadrant mean in the two-quadrant buck-boost converter?
What does the two quadrant mean in the two-quadrant buck-boost converter?
菜鸟遥哥哥 Power technology
IC Selection
[i=s]This post was last edited by jackzym on 2014-7-23 13:04[/i] Can you please tell me what IC should I use for the yellow circle? Thank you!
jackzym Analog electronics
Vivado "Failed to generate and synthesize debug IPs." error solution
Vivado prompts the following error, which may be due to insufficient BRAM. The problem can be solved by reducing the memory depth. [IP_Flow 19-3805] Failed to generate and synthesize debug IPs. error
littleshrimp FPGA/CPLD
Help
When I open Keil 5, the dialog box shown above pops up. Can anyone help me solve this problem?
lwh1 stm32/stm8
Stop mode interrupt (emergency)
Two interrupts are enabled during operation: PA0 and PB11. Before entering STOP mode, PA0 is used to wake up the system, but PB11 is not used to wake up the system. NVIC->ICER[1] = 1PR = 1ISER[1] = 1<
lanshunhua stm32/stm8

Recommended Content

Circuit

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号