• Duration:50 minutes and 34 seconds
  • Date:2019/06/13
  • Uploader:老白菜
Introduction
keywords: parallel computing
Parallel computing is one of the core contents in the parallel algorithm teaching system. It is the basic level of algorithm application in the parallel algorithm teaching system. It is aimed at senior undergraduate students majoring in computer science or graduate students engaged in computing science. It is designed to adapt to high-level students. The rapid development of high-performance computers meets the country's needs for cultivating high-tech talents for the 21st century. To this end, this course strives to be innovative in its content system. While following the course's own discipline, systematization, and completeness, it should fully consider the needs of solving large-scale scientific engineering problems on parallel computers in different application fields, and combine parallel computers with The contents of courses such as architecture, parallel numerical computing, parallel algorithms and parallel programming are organically integrated to form a new type of parallel computing course in China.
Unfold ↓

You Might Like

Recommended Posts

Gallium nitride transistors help make charging circuits smaller and more economical.
When it comes to fast-charging power adapters for consumer devices, high power density and high efficiency are now the two major technical requirements. With fast switching speeds and low on-state res
btty038 RF/Wirelessly
TM4C123 DMA serial port receiving
I have tried to receive SBUS signals using the serial port only with interrupts, but the baud rate of 100000 is too CPU-intensive to receive using the serial port interrupt, which causes some tasks to
627933142 Microcontroller MCU
Amplifier Selection
If the downloaded software requires a decompression password, the password may be: wwww.ec66.com or www.ecbbs.com. If the above password still cannot be decompressed, there are two possible reasons: 1
fighting Analog electronics
The power of the zigbee-CC2530 module is adjusted to 4dBm
The CC2530 module is finally ready. The main thing is to adjust the power output to nearly 4dBm. The distance is similar to that of the Ti original module. :) See the picture: http://chushiwei0903.b2b
rock_chu RF/Wirelessly
Problems in using Guo Tianxiang's development board to do a dot matrix display experiment
Today I am experimenting with 8*8 dot matrix display on Guo Tianxiang's TX-1C MCU development board, but the wiring is wrong. During the experiment, the buzzer of the development board made a sound. I
mangomkt Embedded System
Internet and Smart Buildings
The concept of intelligent building was born in the United States in the 1980s. According to the definition of IBI (Intelligent Building Institute), intelligent building provides an effective and comf
jek9528 Industrial Control Electronics

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号