• Duration:39 minutes and 41 seconds
  • Date:2019/06/13
  • Uploader:老白菜
Introduction
keywords: parallel computing
Parallel computing is one of the core contents in the parallel algorithm teaching system. It is the basic level of algorithm application in the parallel algorithm teaching system. It is aimed at senior undergraduate students majoring in computer science or graduate students engaged in computing science. It is designed to adapt to high-level students. The rapid development of high-performance computers meets the country's needs for cultivating high-tech talents for the 21st century. To this end, this course strives to be innovative in its content system. While following the course's own discipline, systematization, and completeness, it should fully consider the needs of solving large-scale scientific engineering problems on parallel computers in different application fields, and combine parallel computers with The contents of courses such as architecture, parallel numerical computing, parallel algorithms and parallel programming are organically integrated to form a new type of parallel computing course in China.
Unfold ↓

You Might Like

Recommended Posts

UART Bootloader for Hercules TMS570LS04x MCU
UART Bootloader for Hercules TMS570LS04x MCU.pdf
蓝雨夜 Microcontroller MCU
Problem with debugging program in ccs
程序编译可以通过,但是rebuid all时会出现错误,如 Reset_VECB_cy_begin\"pwm_generate_vec.asm\", line 7:AN IDENTIFIER IN THE EXPRESSION IS INVALIDINT1BPHANTOM\"pwm_generate_vec.asm\", line 8:AN IDENTIFIER IN THE EXPRESSION
yangtianle DSP and ARM Processors
[Water Army] F7 emwin text and numerical display learning
[i=s]This post was last edited by wateras1 on 2015-10-18 16:21[/i] I can't help but admire the official gorgeous GUI. I always wonder when I can develop a GUI application of my own. However, a tall bu
wateras1 stm32/stm8
STM32L4 uses serial port 2 to send hello word to PC
[code]#include "stm32l4xx_hal.h" #include "periph.h" UART_HandleTypeDef UartHandle; int main() { char ch[]="hello word"; HAL_Init(); SystemClock_Config(); __HAL_RCC_USART2_CLK_ENABLE(); Gpio_Inits() ;
xutong stm32/stm8
Infrared transmitter and receiver program
Infrared transmitter and receiver source program
shifanno1 MCU
How to prevent pads95 logic from displaying the font replacement confirmation dialog?
As shown in the figure below, every time I open a schematic with pads95 logic, there is a dialog box to confirm the font replacement as shown below! Very annoying! May I ask: 1. What's going on? 2. Ho
yhye2world PCB Design

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号