• You can log in to your eeworld account to continue watching:
  • stationary process
  • Login
  • Duration:51 minutes and 14 seconds
  • Date:2018/06/01
  • Uploader:量子阱
Introduction
keywords:

"Communication Principles" is a core professional basic course for electronic information related majors. This course introduces the general principles of information transmission at the physical layer, that is, the basic principles and related methods of how to achieve information transmission with the help of electrical signals. The content of this course mainly includes: deterministic signal analysis, random signal analysis, analog sinusoidal modulation, digital baseband and frequency band transmission, signal sources, etc. This course is an introductory course in communications, focusing on basic principles and theories, laying a solid foundation for further study.

Teaching videos related to Beijing Postgraduate Entrance Examination Subject 801

Supporting textbooks: Principles of Communication, Third Edition, Zhou Jiongpan, Pang Qinhua, Wu Weiling, Yang Hongwen, Beijing University of Posts and Telecommunications Press

Unfold ↓

You Might Like

Recommended Posts

The driver has been loaded, why can't CreateFile be opened?
The problem is as follows: I made a driver. When loading it, there is indeed relevant output information in the XXX_Init function indicating that the driver has been loaded successfully, but CreateFil
intersong Embedded System
Car Audio Installation Manual
Before deciding to install a car stereo, it is best to understand some common sense, which will definitely be beneficial to you. Purchase For drivers, it is very difficult to choose a high-quality car
guangqiji Automotive Electronics
STM8 firmware library warning issue under IAR
Warning:Remark[Pa091]: operator operates on value promoted to int (with possibly unexpected result)对应语句:GPIOx->DDR &= (uint8_t)(~(GPIO_Pin));
Hanking stm32/stm8
Touch screen control motor, reset procedure and re-touch re-detection sequence problem
I am working on a 51 single-chip microcomputer and LCD touch screen. I make the DC motor rotate by touching an area. I need to reset it by touching the "return" area (the function is equivalent to pre
13011225855 51mcu
What does this mean? I don't understand. It's in the embedded system.
SECTIONS {. = TEXTADDR;.text: {__ro_start = . ;*(.text)__initcmd_start = .;*(.cmd.init)__initcmd_end = .;*(.rodata)__ro_end = . ;}.data ALIGN(4) : {__rw_start = . ;*(.data)__rw_end = . ;}.bss ALIGN(4)
bg8sck Embedded System
After adding hive, wince cannot start
I use s3c2440+wince5 and want to save the registration information in flash. After adding hive, wince cannot start. After deleting it and restarting sysgen, it can start normally. What is the problem?
zyyu Embedded System

Recommended Content

可能感兴趣器件

EEWorld
subscription
account

EEWorld
service
account

Automotive
development
circle

About Us Customer Service Contact Information Datasheet Sitemap LatestNews


Room 1530, 15th Floor, Building B, No.18 Zhongguancun Street, Haidian District, Beijing, Postal Code: 100190 China Telephone: 008610 8235 0740

Copyright © 2005-2024 EEWORLD.com.cn, Inc. All rights reserved 京B2-20211791 京ICP备10001474号-1 电信业务审批[2006]字第258号函 京公网安备 11010802033920号