IU8309 can be used for dual power supply applications with lithium battery and 12V adapter, suitable for 2.7V~12V power supply nodes, anti-breaking sound, AB/D switching power limit, built-in boost module, with adaptive boost function, constant 25W output power Class F mono audio power amplifier.
IU8309C is a Class R mono audio power amplifier suitable for 2.7V~12V power supply nodes, with four anti-breaking sound modes, AB/D switching, power limit, built-in BOOST boost module and the boost module has adaptive boost function. When powered by a single lithium battery, IU8309C can drive a load as low as 4Ω and output a maximum constant power of 19W; when powered by two lithium batteries in series, IU8309C can drive a load as low as 3Ω and output a maximum constant power of 25W. The design of class AB and class D switchable modes minimizes the interference of the power amplifier to FM in the audio subsystem. IU8309C breaks through the limitations of single and double lithium battery power supply, and provides terminal products with more extreme power output, making the power output of terminal products comparable to the output power of 12V lead-acid battery-powered audio systems.
The fully differential architecture and extremely high PSRR of IU8309C effectively improve the ability to suppress RF noise. The filter-free PWM modulation structure and built-in BOOST boost module and IU8309C's proprietary AERC (Adaptive Edge Rate Control) technology greatly reduce EMI interference within the full bandwidth of the audio. For a 60cm audio line, it has a margin of more than 20dB under the FCC standard. In addition, IU8309C has built-in overcurrent protection, short circuit protection and overheating protection, which effectively protects the chip from being damaged under abnormal working conditions.
IU8309C provides a small TSSOP20-PP package for customers to choose from. Its rated operating temperature range is -40℃ to 85℃.
Previous article:IU632 is compatible with DRV632/SGM8903/AD22650 and supports 3Vrms audio linear driver
Next article:IU8373 is compatible with CS83711, powered by two lithium batteries with 8.4V, built-in boost 17W stereo Class D audio amplifier IC
- Popular Resources
- Popular amplifiers
- Huawei's Strategic Department Director Gai Gang: The cumulative installed base of open source Euler operating system exceeds 10 million sets
- Analysis of the application of several common contact parts in high-voltage connectors of new energy vehicles
- Wiring harness durability test and contact voltage drop test method
- Sn-doped CuO nanostructure-based ethanol gas sensor for real-time drunk driving detection in vehicles
- Design considerations for automotive battery wiring harness
- Do you know all the various motors commonly used in automotive electronics?
- What are the functions of the Internet of Vehicles? What are the uses and benefits of the Internet of Vehicles?
- Power Inverter - A critical safety system for electric vehicles
- Analysis of the information security mechanism of AUTOSAR, the automotive embedded software framework
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
- Innolux's intelligent steer-by-wire solution makes cars smarter and safer
- 8051 MCU - Parity Check
- How to efficiently balance the sensitivity of tactile sensing interfaces
- What should I do if the servo motor shakes? What causes the servo motor to shake quickly?
- 【Brushless Motor】Analysis of three-phase BLDC motor and sharing of two popular development boards
- Midea Industrial Technology's subsidiaries Clou Electronics and Hekang New Energy jointly appeared at the Munich Battery Energy Storage Exhibition and Solar Energy Exhibition
- Guoxin Sichen | Application of ferroelectric memory PB85RS2MC in power battery management, with a capacity of 2M
- Analysis of common faults of frequency converter
- In a head-on competition with Qualcomm, what kind of cockpit products has Intel come up with?
- Dalian Rongke's all-vanadium liquid flow battery energy storage equipment industrialization project has entered the sprint stage before production
- Allegro MicroSystems Introduces Advanced Magnetic and Inductive Position Sensing Solutions at Electronica 2024
- Car key in the left hand, liveness detection radar in the right hand, UWB is imperative for cars!
- After a decade of rapid development, domestic CIS has entered the market
- Aegis Dagger Battery + Thor EM-i Super Hybrid, Geely New Energy has thrown out two "king bombs"
- A brief discussion on functional safety - fault, error, and failure
- In the smart car 2.0 cycle, these core industry chains are facing major opportunities!
- The United States and Japan are developing new batteries. CATL faces challenges? How should China's new energy battery industry respond?
- Murata launches high-precision 6-axis inertial sensor for automobiles
- Ford patents pre-charge alarm to help save costs and respond to emergencies
- New real-time microcontroller system from Texas Instruments enables smarter processing in automotive and industrial applications
- The chip shortage will end in 2023 and there may be overcapacity in 2024. Do you believe it?
- Can the shared power bank industry really make money?
- BlueNRG-series level 1 training materials
- A detailed introduction to the control technology of various DC motors
- Low-cost oscilloscope discussion, come in
- EEWORLD University Hall----Live Replay: Internet of Everything-Shijian Company and Microchip experts jointly discuss IoT solutions
- [Discussion] I'm looking at a product recently, a 400x400 camera for car use
- DSP Power Budget Digital Output Voltage Regulation
- Selling some components
- Detailed introduction to crystal oscillators and crystal parameters