Typical application of Xindingsheng microcontroller MCU: disinfection toothbrush box-EEWORLD

Collect

The disinfection light source uses UVC+UVA short-wave LED ultraviolet light, which has a wavelength of 200-275nm and 320-420nm respectively. UVC deep ultraviolet sterilization is currently a commonly used disinfection technology. Deep ultraviolet can release higher energy and has a very obvious effect on bacteria and viruses. It can directly kill bacteria and viruses by destroying their internal DNA structure after irradiation. UVA is used to produce visual effects and increase consumers' experience.

Disinfectant toothbrush box circuit diagram V1.0

Schematic diagram of disinfection toothbrush box

Technical parameters:

Power supply voltage: 3V (2 AA batteries); static power consumption: <5uA; disinfection time: 5 minutes; disinfection working current: <160mA; ambient temperature: -20℃~+65℃; ambient humidity: 30%RH~80%RH.

Disinfectant toothbrush box effect picture

Reference address：Typical application of Xindingsheng microcontroller MCU: disinfection toothbrush box

Previous article：Yuanxiang FP6276:6A synchronous rectification PWM boost IC
Next article：IM2605 type-c power management chip design schematic

Recommended ReadingLatest update time:2024-11-16 10:32

Design of intelligent water dispenser based on 51 single chip microcomputer

1. Hardware Solution This design is a temperature control system for a water dispenser based on a single-chip microcomputer. The system can detect the water temperature of the water tank of the water dispenser in real time, and can display the water temperature of the water tank of the water dispenser through a digita

[Microcontroller]

Design of intelligent water dispenser based on 51 single chip microcomputer

MPLAB IDE v8.92 for PIC microcontrollers only supports English directories

MPLAB IDE v8.92 only supports English directories, so generally you should copy the corresponding project to the D drive, then open it for compilation, and finally if you want to save the project, you should copy it back to the location you want to save it to. When in the Chinese directory, an error "Cannot find the

[Microcontroller]

STC15 Series MCU-Environmental Monitoring Equipment

main.c /** * Product Name: Environmental Monitoring Equipment * Product Definition: * (1) The microcontroller collects temperature every 1 second through the DS18B20 temperature sensor. * (2) The microcontroller collects the time from the DS1302 clock chip every 200 milliseconds. * (3) Real-time time display th

[Microcontroller]

Source program of microcontroller serial port controlling stepper motor

#include reg52.h #include intrins.h #define uchar unsigned char #define uint unsigned int #define LED P1 //Because the stepper motor is a reduction stepper motor, the reduction ratio is 1/64, //So when N=64, the stepper motor spindle rotates one circle //Please short-circuit the J2 jumper cap before use, set the ser

[Microcontroller]

Intel's Silicon Labs launches OLEA U310 automotive SoC, which can replace six standard MCUs

On June 12, Silicon Mobility, a company in the electric vehicle motor control field, released the automotive field programmable control unit OLEA U310, claiming that a single OLEA U310 SoC can replace up to 6 standard MCUs. Silicon Mobility is a French company that specializes in the design of motor control chi

[Automotive Electronics]

Intel's Silicon Labs launches OLEA U310 automotive SoC, which can replace six standard MCUs

Practical Analysis of 8051 MCU (Taking STC89C52RC as an Example) | 03 - LED Flowing Light

1 Schematic It is not difficult to see from the picture that the entire P2 port is connected to the LED, and the entire P2 port needs to be driven when writing code. 2 Code #include "reg52.h" //This file defines some special function registers of the microcontroller #include intrins.h //Because we need to use t

[Microcontroller]

Practical Analysis of 8051 MCU (Taking STC89C52RC as an Example) | 03 - LED Flowing Light

Design of Commonly Used Driver and Isolation Circuits for Single Chip Microcomputer I/O

[Microcontroller]

Make a calculator with a single chip microcomputer

Hardware Circuit program #include AT89X51.H #define DIN P1_0 #define CLK P1_2 #define LOAD P1_1 unsigned char key_h,key_l,key_code; unsigned char ADS,i,j,m,n; unsigned char n_bit=0; unsigned char flag=0; unsigned char key_num ={7,8,9,'/',4,5,6,'*',1,2,3,'-','c',0,'=','+'}; unsigned char data1 ={0}; unsigned char

[Microcontroller]

Make a calculator with a single chip microcomputer

Popular Resources
Popular amplifiers