A brief analysis of S7-1500 control servo drive-EEWORLD

Collect

1 System Configuration System hardware configuration table and network view

CPU 1513-1 PN 6ES7 513-1AL00-0AB0
TP900 Comfort 6AV2 124-0JC01-0AX0
SINAMICS S110 CU305 PN V4.4 6SL3 040-0JA01-0AA0
SINAMICS S110 CU305 PN V4.4 6SL3 040-0JA01-0AA0

2 PLC system configuration, process axis configuration

A. PLC Configuration

B. Horizontal axis configuration

C. Vertical axis configuration

D. Insert the technological objects Axis_H and Axis_V

E. Configuration of technology object Axis_H

Note: The message must be consistent with the configuration message in Starter ; the reference speed, maximum speed, single-turn steps, number of revolutions, GN_XIST1, and GN_XIST2 can all be viewed in the Starter online parameters.

The reduction ratio and pitch are calculated according to actual conditions.

Soft and hard limits do not need to be configured in the initial stage of debugging, and can be added later when they are perfected.

F. The configuration of the technological object Axis_V is the same as above

3 Starter Configuration

A. Create a new project

Config drive unit

The configuration in the message and the process axis must be consistent

4 PLC manual debugging program writing

A. Driver Enable

B. Reading of driver StatusWord, ErrorWord, and WarningWord

C. Motor Current position reading

D. Process alarm reset program writing

E. Jog program writing

F. Zero return program writing

G. Absolute position motion program writing

Keywords：S7-1500 Reference address：A brief analysis of S7-1500 control servo drive

Previous article：How does PLC detect motor failure?
Next article：Share an example of constant pressure water supply controlled by frequency converter and touch screen

Recommended ReadingLatest update time:2024-11-16 11:30

PLC Programming Example: S7-1500 and two S7-1200 Profinet IO communication

1. Create a new project and add CPU 1511C-1 PN. Add a new subnet PN/IE_1 and set IP: 192.168.254.150 2. Switch to the network view and add the controller CPU1217 from the "Hardware Catalog" on the right. 3. Select CPU1217 and switch to "Device View". Double-click the CPU network port, select "Etherne

[Embedded]

PLC Programming Example: S7-1500 and two S7-1200 Profinet IO communication

SIMATIC S7-1500 PLC Ladder Diagram Programming Example

The empirical design method is to modify and improve the original ladder diagram based on some typical ladder diagrams according to the specific requirements of the control system for specific objects. This method is suitable for people with certain work experience who have ready-made materials. Especially when the

[Embedded]

SIMATIC S7-1500 PLC Ladder Diagram Programming Example

Popular Resources
Popular amplifiers