First of all, this problem is that the optimization level set by the IAR compiler is too high. You can just lower the optimization level.
Solution:
In options->C/C++compile---->optimization, there is a column called Leval, and below it there are 4 options: None, low, medium, and high.
Selecting Low can solve the above problem.
Previous article：Solution to IAR not being able to run single-step when it reaches a breakpoint
Next article：Solve the problem that IAR cannot set breakpoints
- Popular Resources
- Popular amplifiers
LM613IMDC
Recommended Content
Latest Microcontroller Articles
- Learn ARM development(16)There are many things to learn about ARM, and interrupts are definitely something that needs to be learned. Since the CPU introduced interrupts, it has truly entered the multi-tasking system and greatly improved work efficiency. ...
- Learn ARM development(17)Because all embedded systems use interrupts, how does my S3C44B0 interrupt the process? Then I need to understand the whole process. To understand it in depth, the best way is to write a program ...
- Learn ARM development(18)Last time, we have learned about the interrupt handling process of ARM and how to set the interrupt function. So, does it work like this? The answer is no. Because S3C44B0 has several registers that control ...
- Embedded system debugging simulation toolAfter the embedded hardware system is designed, it needs to be debugged. Whether it is hardware debugging, software debugging or program solidification, debugging simulation tools are needed. ...
- A small question that has been bothering me recently has finally been solved~~Recently, I have not been able to understand the concept of drivers very well. Sometimes I can get a feel for it by combining some USB examples written by others, but because the ARM system does not directly explain the pins like the microcontroller ...
- Learn ARM development (1)
- Learn ARM development (2)
- Learn ARM development (4)
- Learn ARM development (6)
He Limin Column
Microcontroller and Embedded Systems Bible
Professor at Beihang University, dedicated to promoting microcontrollers and embedded systems for over 20 years.
MoreSelected Circuit Diagrams
MorePopular Articles
- LED chemical incompatibility test to see which chemicals LEDs can be used with
- Application of ARM9 hardware coprocessor on WinCE embedded motherboard
- What are the key points for selecting rotor flowmeter?
- LM317 high power charger circuit
- A brief analysis of Embest's application and development of embedded medical devices
- Single-phase RC protection circuit
- stm32 PVD programmable voltage monitor
- Introduction and measurement of edge trigger and level trigger of 51 single chip microcomputer
- Improved design of Linux system software shell protection technology
- What to do if the ABB robot protection device stops
MoreDaily News
- Detailed explanation of intelligent car body perception system
- How to solve the problem that the servo drive is not enabled
- Why does the servo drive not power on?
- What point should I connect to when the servo is turned on?
- How to turn on the internal enable of Panasonic servo drive?
- What is the rigidity setting of Panasonic servo drive?
- How to change the inertia ratio of Panasonic servo drive
- What is the inertia ratio of the servo motor?
- Is it better for the motor to have a large or small moment of inertia?
- What is the difference between low inertia and high inertia of servo motors?
Guess you like
- Study and use of DSP6678 chip
- Simple and fast design of LC filter
- 【E840-DTU】Evaluation Summary
- Problems with display of characters and numbers in LCD?
- 【ST NUCLEO-G071RB Review】TIM-PWM
- How to determine the frequency of sine wave collected by microcontroller AD?
- Answer the questions to win prizes! ADI Technology Express - Automotive Application Entertainment and Information Interaction Solutions
- [NXP Rapid IoT Review] Hello World project reads sensor values that are always 0
- Introduction to 5G Small Cells
- 【GD32L233C-START Review】Three Power Consumption
京公网安备 11010802033920号